Laserfiche WebLink
fntertek •• <br />1117 Arlingate Lane <br />Columbus, OH 43228 <br />REFRIGERANT RECOVERY/RECYCLING EQUIPMENT <br />CERTIFICATION PROGRAM <br />Program of the Air -Conditioning, Heating and Refrigeration Institute <br />INSPECTION REPORT RECEIVE[ <br />REPORT SERIAL NUMBER: RRRE-11008-1 MAY y 1 a 205 <br />INSPECTION STATUS: NO SUBSTANTIVE CHANGES - PASS <br />TESTED FOR: AHRI Certification Program for ENVIRONMENTAL <br />Refrigerant Recovery/Recycling Equipment <br />2111 Wilson Blvd., Suite 500 HFAITH nFCAQTAAFNT <br />Arlington, VA 22201 <br />UNIT INSPECTED: <br />RAPREC SUPPORT, INC. (MODEL EM -1, EL MACHINO) <br />UNIT SERIAL NUMBER: <br />10067 <br />UNIT TYPE: <br />RECOVERY <br />REFRIGERANTS: <br />R-114, R -134A, R-22, R -407C AND R -410A <br />COMPRESSOR MANUFACTURER: <br />DORIN <br />COMPRESSOR MODEL: <br />2GVSBLIS, WITH 6Ye" DIA. PULLEY AND HENRY S-9010 OIL LEVEL CONTROLLER <br />COMPRESSOR SERIAL. NO.: <br />11105202 <br />MOTOR (BELT/DIRECT DRIVE): <br />BELT DRIVE THROUGH CLUTCH, HONDA GX270 GASOLINE POWERED ENGINE, 9.0 HP, <br />INSPECTION PROCEDURE: <br />MOTOR PULLEY 4'/4" DIP.., MANUALLY THROTTLE CONTROLLED <br />INLET ACCUMULATOR TYPE: <br />HENRY S-7061 HE, %" FPT PORTS, ''/z" MFLARE HEAT EXCHANGER PORTS <br />DISCHARGE SEPARATOR TYPE: <br />HENRY S-5887, %" FPT PORTS, %" MFLARE OIL RETURN PORT <br />CONDENSER TYPE: <br />(2x) FINNED TUBE, 3 Rows, 14"W x 14"H, 3/8" DIA. TUBING <br />CONDENSER BLOWER TYPE: <br />(2X) DAYTON, MODELS 2C986 (Cw) AND 5C124 (CGw), 9'/i" DIA., BELT -DRIVEN BY <br />HONDA ENGINE WITH 3%a" DIA. MOTOR PULLEY AND 53/4" DIA. BLOWER PULLEY <br />RECEIVER: <br />NONE <br />CRO VALVE SETTING/ VERIFIED: <br />MANUALLY THROTTLED BASED ON INCOMING AND DISCHARGE REFRIGERANT <br />PRESSURES, SUCTION — SPORLAN CROT-60 0/60, CONDENSER —SPORLAN ORI -6 65/225 <br />LABELS: <br />AHRI 740 LABEL, EPA STATEMENT <br />OTHER COMPONENTS: <br />'t/z" MFLARE HOSE SUCTION PORTS AND HOSE, %" MFLARE HOSE DISCHARGE PORT <br />AND HOSE, VALVES FOR PUMPOUT MODE <br />CONDITION OF UNIT: <br />Unit appears to be new with no observable defects. <br />DATE INSPECTED: <br />February 17, 2011 <br />INSPECTION PROCEDURE: <br />Certification Program Operational Manual, OM -740 dated September 2010. <br />NOTICE: <br />This report is for the exclusive use of Intertek's Client and is provided pursuant to the agreement between Intertek <br />and its Client. Intertek's responsibility and liability are limited to the terms and conditions of the agreement. <br />Intertek assumes no liability to any party, other than to the Client in accordance with the agreement, for any loss, <br />expense or damage occasioned by the use of this report. Only the Client is authorized to permit copying or <br />distribution of this report and then only In its entirety. Any use of the Intertek name or one or its marks for the sale <br />or advertisement of the tested material, product or service must first be approved in writing by Intertek. The <br />observations and test results In this report are relevant only to the sample tested. This report by itself does not <br />imply that the material, product, or service is or has ever been under an Intertek certification program. <br />Document Streamline Registered: G:\Engineering\740 RecRec\2011 tests\RapRec\RRRE-11008-1 <br />iB Aiq <br />DON BUTT REVIEWEDBY: RAMZI AWI <br />SENIOR ASSOCIATE ENGINEER OPERATIONS/ENGINEERING MANAGER <br />Project Number G100334045 <br />