Laserfiche WebLink
Jun, 11. 2014 9:30AM <br />No, 4257 P. 3 <br />26 Smart Sensor Setup Vac Sensor Setup <br />Vac Sensor Setup <br />If necessary, press STE=P until you see the message: RECEIVED <br />s 1: VAC SFNSOR SETUP <br />PRESS aENjER> JUN 112014 <br />Press ENTER: ENVIRONMENTAL HEALTH <br />s 1: SELECT PUMP # DEPARTMENT <br />NONE <br />You must select the pump that will provide the source of vacuum for this Vac Sensor or a Setup Data Warning will <br />be posted for this Vac Sensor. If necessary, press CHANGE until the correct pump's control device displays (QX <br />(PLLD), WX (WPLLD), or RX (Output Relay)]. NOTE: an Output Relay must be set to Pump Control Output to be <br />assigned as a pump. If the selected pump output relay is not assigned to a pump sense device, a Setup Data <br />Warning for this Vac Sensor will be posted. <br />Press ENTER to confirm your entry. <br />Press STEP to continue.: <br />s 1: (Vacuum Label) <br />VOLUME: 501. <br />Enter the volume in gallons of the interstitial space being monitored by the Vac Sensor. The permitted range is 1 to <br />500 gallons_ Default is 501. A Setup Data Warning alarm will activate if a volume between 1 and 500 is not <br />entered.' <br />Press CHANGE and enter the interstitial space volume. Press ENTER to confirm your entry. <br />Press STEP to continue.: <br />s 1, (Vacuum Label) <br />RELIEF VALVE: NO <br />Steel Tank <br />If this Vac Sensor is monitoring a steel tank's interstitial space, a relief valve is usually not needed. Press STEP <br />to accept the default NO. Press Tank/Sensor to setup another Vac Sensor. <br />Fiberglass Tank <br />IF this Vac Sensor is monitoring a fiberglass tank's interstitial space, a relief valve is required to prevent excess <br />vacuum from damaging the tank Press CHANGE and select YES. Press ENTER to confirm your entry. <br />Press STEP to continue.: <br />s 1: (Vacuum Label) <br />RELIEF VALVE PRESSURE: -9.0 <br />Enter the pressure at which the installed Relief Valve is rated to open (the vent pressure is stamped on the <br />body of the V -R Relief Valve). The permitted range is -5 to -9 psi. Default vent pressure is -9. Press ENTER to <br />confirm your entry. Press Tank/Sensor to setup another Vac Sensor. <br />26-4 <br />