Laserfiche WebLink
A Results of Testing/Servicing <br />Software Version Installed: 421.00 <br />Complete the following checklist: <br />® Yes <br />❑No <br />Is the audible alarm operational? <br />® Yes <br />❑No <br />Is the visual alarm operational? <br />® Yes <br />No <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />® Yes <br />❑No <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />❑ Yes <br />No <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />®N/A <br />operational? <br />❑ Yes <br />❑No <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />®N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm positive shut down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. <br />® Yes <br />❑No <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />❑N/A <br />mechanical overfill prevention valve is installed), is the over -fill warning alarm visible and audible at the tank <br />fillpoint(s) and operating ro erl ? If yes, at what percent of tank capacity does the alarm trigger? 90% <br />❑Yes <br />No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />❑ Product; ❑ Water. If es, describe causes in Section E, below. <br />EE]Yes®No <br />❑ No <br />Was monitorin s stem set -u reviewed to ensure ro er settin s? Attach set u re orts, if a licable <br />❑ No <br />Is all monitoring equipment oerational per manufacturer's s ecifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Page 2 of 3 <br />