COMPLIANCE INFO 1988 - 2006 - Laserfiche WebLink

Home Browse Search

SECTION 3 ♦ Containment Crossover Detail 2.2.4 Fitting Assembly All containment fittings consist of two halves with flanges as shown in Fig. 2.2.3. The bottom half has threaded in- serts for ease of assembly. Apply adhesive to Pipe must fit snugly into fitting socket so that no gap exists FIGURE 2.2.5 TABLE 2.3.1 Containment Crossover Information These fittings are assembled with adhesive and %-20 wash- er -head bolts that are furnished with the fittings. The re- quired bolts are supplied in small plastic bags. If extra bolts are required, they can be purchased from your dis- tributor. Or, you can use standard %-20 x 1" long hex head bolts. If you use standard bolts, place a flat washer on the bolt before torquing. The bonding surfaces of the containment fittings are sup- plied from the factory pre -sanded. Two-piece secondary containment fittings must be joined using a greater amount of adhesive than is necessary for joining bell and spigot joints of product piping (see Fig. 2.2.5). SECTION 3 • CONTAINMENT CROSSOVER DETAIL 2.3.1_ Preparation When ins tti ing a secondary containment system from Smith Fiberglass Products, some preparation is necessary if � e`closest possible separation of lines is required. To minimize the overall change in elevation when installing a containment crossover, it is necessary to shorten one (1) Actual length of the product nipple will vary slightly because of different insertion lengths due to variations in tapers. Remove From Remove From C D Containment 45' Crossover Side Run of Product(1) Containment Pipe Size Elbow Tee Nipple Size Nipple Size (in.) (mm) (max. in.) (max. mm) (max. in.) (max. mm) (min. in.) (min. mm) (min. in.) (min, mm) 3 75 1.25 32 1.50 38 2 x 8 50 x 200 3 x 6 75 x 150 4 100 2.00 51 1.63 41 3 x 8 75 x 200 4 x 6 100 x 150 6 150 1.25 32 1.00 25 4 x 10 100 x 250 6 x 8 150 x 200 (1) Actual length of the product nipple will vary slightly because of different insertion lengths due to variations in tapers. Containment A B C D E Note:Match drill two holes TABLE 2.3.2 Pipe Separation Distances P P (in.) (5/16, M at a distance of d4" o 0 0 (1199 mm) from the cut end of (in.) 3 7.5 10.6 6.5 10 the 45' elbow and the tee. 4 8.5 12 7.5 12 16.5 6 10.65 15 8 14.75 22 0 0 qT min o 0 A (100 mm) �64 mm) Cdti 0 i t `E� NOTE: The 2.5" (64 mm) critical dimension must be inspected in the field. FIGURE 2.3.1 Containment A B C D E Pipe (in.) (in.) (in.) (in.) (in.) (in.) 3 7.5 10.6 6.5 10 14.5 4 8.5 12 7.5 12 16.5 6 10.65 15 8 14.75 22 Containment A B C D E Pipe (mm) (mm) (mm) (mm) (mm) (mm) I 75 191 269 165 254 368 100 216 305 191 305 419 150 271 381 203 375 559 24 Installation Instructions