Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 434.00 <br />Complete the following checklist: <br />• Yes <br />i- No* <br />Is the audible alarm operational? <br />• Yes' <br />No* <br />Is the visual alarm operational? <br />i% Yes <br />t� No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />is Yes <br />No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with <br />heir roper operation? <br />i Yes <br />t' No* <br />N/A <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />Yes <br />No* <br />N/A <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring <br />system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check <br />all thatapply) Sump/Trench Sensors; I Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? C` Yes; r No <br />Yes <br />C No* <br />!+ N/A <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill <br />prevention valve Is Installed), is the overfill warning alarm visible and audible at the tank fill points) and operating properly? If <br />so at what percent of tank capacity does the alarm trigger? % <br />t Yes' <br />G No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E below. <br />r Yes* <br />No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />r Product r Water. If yes, describe causes in Section E below. <br />r* Yes <br />F No. <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />Yes <br />(— No* <br />s all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />all four trans sumps had 208 sensors that were functional and passed. <br />Monitoring System Certification Page 2 of 3 12107 <br />