COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

04/02/2001 ID Lz Pont Page 3 of 5 Product Usage Data Sheet - 12395S coat to achieve flow. If additional flow and leveling are desired, add up to 5 - 10% of the appropriate ChromaPremierTM Reducer. Tips for Success Allow each coat to flash a full 15 minutes. Flash/Dry Times Flash between Coats 15 minutes. Force Dry Flash before Force Dry: 0 - 10 minutes Force Dry Cycle Time: 30 minutes @ 140° F. Dust Free: At cool down. Time to Handle (Assemble) : 1 hour after cool down. Time to Polish: 1 hour after cool dawn. Time to Stripe: 1 hour after cool down. Time to Deliver: 4 - 6 hours after cool down. Two-Toning: 1 hour after cool down. Infrared Dry: Refer to the Infrared Guide for specific setup recommendations. Blending Panel repair is the approved procedure for single-stage warranty repairs. This allows the refinisher to attain the recommended film builds. If the refinisher chooses to blend, there are two techniques for blending ChromaPremierTM Single-Stage, depending on the size of the repair area. ■ For limited blend areas use ChromaPremierTM Slow Reducer 12385S in a two-cup procedure. Mix ready-to-spray ChromaPremierTM Single-Stage with 200 - 300% reducer. With color in one cup and color/reducer in a second cup, apply the first coat of color; then apply color/reducer mixture at the color edge using reduced air pressure at the gun. Apply the second coat of color, and again, blend the edge with the color/reducer mixture. ■ For extended blend areas, use ChromaClear(R) 78005 in a stepped-out procedure. Activate 7800S normally, but over-reduce it with the appropriate ChromaPremierTM Reducer 200 - 300%. To perform the blend, apply single-stage color to hiding. In the last coat, mix the above over-reduced clear into the ready-to-spray color at 1:1, and apply to the blend edge using reduced air pressure at the gun. Finally, apply over-reduced clear by itself to the blend edge. Tips for Success As an alternative to blending, apply ChromaPremierTM 72400S or ChromaClearTM 7800S over the single-stage repair out to the panel edge or styling line. Recoatability/Re-repair ChromaPremierTM Single-Stage may be recoated at any stage of dry or cure. If recoating after 24 hours, scuff sand with 600 grit or finer. Polishing Optimum Times Force Dry: 1 - 24 hours. Sanding Use 1500 grit wet or finer. Or use P1500 DA or finer.