Laserfiche WebLink
�FC�i"�'EL) <br />JPA 17 cull <br />ENVIRONMENTAL HEALTH <br />DEPARTMENT <br />ADHESIVES <br />See section on adhesives for mixing, usage and labeling in- <br />formation <br />Filler For Red Thread IIA Pipe <br />For Red Thread IIA pipe, filler is required to thicken the adhe- <br />sive for secondary containment joints. It is packaged in pre- <br />measured quantities for use with 7014 or 8014 and 7069 or <br />8069 adhesive kits. One bag of filler is used for each adhesive <br />kit. Before adding the filler to the mixed adhesive, be sure both <br />the adhesive base and hardener are thoroughly mixed togeth- <br />er. All of the filler in the bag should be used. The thickened <br />adhesive may be applied with either the brush or the mixing <br />stick provided in the kit. <br />*If 7014 or 8014 adhesive kits are used for secondary contain- <br />ment, increase the number of kits in table by 50°x. <br />The number of adhesive kits per containment fitting is based <br />on applying a 1/16" (1.6 mm) minimum thickness of adhesive <br />to both halves of the fitting and to the pipe ends. <br />Complete information and safety precautions are packaged <br />with each adhesive kit. Review all safety precautions thorough- <br />ly before mixing the adhesive. <br />Adhesive Disposal - See section on adhesive for instructions. <br />52 <br />