Laserfiche WebLink
• Containment fittings are then joined with bolts. Insert <br />and begin threading each bolt into the pre -inserted nut <br />by hand. A nut driver or powered device can be used <br />to assemble the bolts. If a power tool is used to tighten <br />the bolts, confirm tightness of each bolt with a nut driver. <br />Note: Tighten the inner radius bolts first. <br />I <br />{ is <br />.,l Termination <br />Fitting <br />90° Elbow 45° Elbow <br />- y r: Repair Coupling <br />Tee <br />TERMINATING THE SECONDARY CONTAINMENT <br />Clamshell Termination Assembly <br />Apply adhesive to all bonding surfaces after sanding, as de- <br />scribed above. DO NOT put any adhesive in the center portion <br />of the termination sleeve body. Position the clamshell termi- <br />nation assembly over the cut jacket so that the shoulder in <br />the assembly fits against the cut jacket end. Particular care <br />must be given to assure excess adhesive is not used as it may <br />cause sealing of the containment. See Figure below. <br />Test Valve— <br />Clamshell Termination Sleeve <br />68 <br />pipe <br />ENVIRONMENTAL HEALTH <br />CE�.n.RTME��T <br />