Laserfiche WebLink
A. Results of Testing/Servicing <br />Software Version Installed: <br />(;om lete <br />the fo110 <br />Yes <br />❑ Noy° <br />Yes <br />❑ Noy° <br />Yes <br />❑ No* <br />Yes <br />❑ No* <br />❑ Yes <br />❑ No* <br />1g( NIA <br />PL Yes <br />❑ No* <br />❑ lel/A <br />❑ Yes ❑ No* <br />N/A <br />❑ Yes* 4 No <br />❑ Yes* I A No <br />checklist: <br />Is the audible alarm operational? <br />Is the visual alarm Operational? <br />Were all sensors visuallins ected, functional) tested, and confirmed operational? <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their DrODer operation? <br />If alarms are relayed to a remote monitoring station, is <br />operational? all communications equipment (e.g. modem) <br />For pressurized piping systems, does the turbine automaticall shut down if thepi m second containment <br />monitoring system detects a leak, fails to operate, or is electrically disconnected?If yes: whichsensors initiate <br />Positive shut -down? (Check all char apply) 9 Sum /Trench Sensors; <br />Did Xxi confirm Positive shut -down due to leaks and sensor failure/disconDispen Dispenser Containment Sensors. <br />For tank systems that utilize the monitoring Yes; El No. <br />b system as the g device (i.e, no <br />Primary tank overfill warnin <br />mechanical overprevention valve is installed), is the overfill warning alarm visible and audible at the tank- <br />fillpoint(s) and o eratin ro erl ? If so, at whatpercent of tank Capacity does the alarm Iris er? <br />Was -any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement Parts in Section E, below. <br />Was liquid found inside any secondary containment systems dg y y esi ned as dr s stems? <br />Product; L) Water. If es, describe causes in Section E, below. (Check all that apply) ❑ <br />JX Yes ❑ No* Was monitorings stem set -u reviewed to ensure ro er settings? Attach set u re orts, if applicable <br />Yes ❑ No* Is all monitoring e ui ment o erational er manufacturer's s ecifications? <br />In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Page 2 of 3 <br />03/01 <br />