Laserfiche WebLink
BORETE <br />E <br />CH <br />4 <br />3 2 1 <br />M 13-1 V, j�-(ViMR-W Fig.13-1 Conveyor Belt Adjusting Device <br />Note that if there is no belt deviation, the tensioning range of rods at both sides should be kept <br />the same, or otherwise, belt deviation can be induced. <br />Upon completion of position adjustment, the lock nut should be locked up. <br />9gfQ Skew Adjustment <br />MAIAIMARIf r�YRPMQI M' tM: <br />litkAla, -LTRRIA M -MA , r�n::i�C 1 1 fp711�J 7 F <br />In case of belt deviation, immediately carry out skew adjustment, as seen in the following <br />operating steps: <br />Similar to tensioning, instead of adjusting the rods at both sides simultaneously, tension the rod <br />to which the belt deflects only. <br />During the adjustment, the belt should be in running state. After completion of certain <br />distance adjustment, observe and gradually adjust the belt deviation only when the belt <br />becomes stable at its new position. <br />13.2, g7r(, SCREW CONVEYOR <br />38 <br />