Laserfiche WebLink
D. .Results of Testing/Servicing <br /> Software Version Installed: <br /> Co Tete the following checklist: <br /> es I ❑ No* Is the audible alarm operational? <br /> PO�es I ❑ No* Is the visual alarm operational? <br /> Dy,yes I ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ o* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> J!J N/A operational? <br /> Cl YesNo* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> El N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑ Yes; ❑No. <br /> ❑ Yes ❑�jo* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> �N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s) and operating properly? If so,at what percent of tank capacity does the alarm trigger? <br /> ❑ Yes* No Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> Yes* ❑ No Was iquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> roduct; ❑ Water. If yes, describe causes in Section E,below. <br /> ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes I ❑ No* I Is all monitoring equipment operational per manufacturer's specifications? <br /> *In Section E below, describe how and when these deficiencies were or will be corrected. <br /> r ���� -n���E <br /> E. Comments: Qtoitt.14�-L btw* ` —s-r��c t l'S pre-�OQKEZ <br /> -TO-5TIt&k <br /> 'p I�ESF I �oT9dM oG T-Z -Tka.�a i�� lP. <br />