Laserfiche WebLink
i. Laboratory quality control limits f. Injection date and time <br /> I Calculated results g. Injection amount <br /> k. Notes or explanation of any outliers h. Dilution factor(or concentration factor if trap is used) <br /> I. Detector <br /> j. Retention time(RT) <br /> (3)Provide additional information,as specified,for different types of analyses.Tabulate and k. Peak area <br /> present in a clear legible format all information according to the following grouping: I. Concentration in pg/L(Cone)(sample results reported in ppbv or ppmv must <br /> >< be converted in pg/L) y, <br /> (A). Initial calibration 1, M. Total number of peaks found by each detector <br /> .yy n. Unidentified peaks and/or other analytical remarks <br /> a. Standard source(STD Lot ID No.) ' 1- o. Surrogate results ' a. <br /> b. Detector ' p. Control limits + <br /> C. Retention time(RT) t ,'' a <br /> 1r <br /> d. Standard mass or concentration(Mass/Cone) <br /> ,. <br /> e. Peak area(Area) <br /> f. Response factor(RF) r "- <br /> g. Average response factor(RIFN) +' ! ` fs <br /> h. Standard deviation(SDn 1)of RF,[e, <br /> n <br /> [=IRF,.-RFJV(n-1)1' , <br /> n•rumM1s dpoYNSNhhlel relitr&bn � - ' <br /> 1. Percent relative standard deviation(%RSD),i.e.,(SDn.t/RF„J x 100 N <br /> j. Acceptable range of%RSD(ACC RGE) <br /> (B). Daily calibration check sample <br /> Nit <br /> a. Source of standard k <br /> b. Detector w4e' <br /> C. Retention time(RT) <br /> d. Standard mass or concentration <br /> e. Peak area <br /> • f. Response factor(RF) '1 <br /> g. Percent difference between RF and RFe„e from initial calibration(%DIFF) <br /> h. Acceptable range of%DIFF(ACC RGE) <br /> (C). Laboratory Control Sample(LCS). Same format as daily calibration check sample e <br /> (D). Soil gas sample <br /> a. Sample identification <br /> b. Sampling depth <br /> C. Purge volume <br /> d. Vacuum pressure <br /> e. Sampling date and time <br /> 12/10/2009 -95- 12/10/2009 -96- <br />