COMPLIANCE INFO 2016 - Laserfiche WebLink

Home Browse Search

Cleaffiew SAFETY DATA SHEET Product name ClearView Crystal Clarifier Revision date 12-3-14 Section 5 Fire - fighting measures Flammable Limits: Not Available Extinguishing Media: Water fog, carbon dioxide, foam, dry chemical. Special Firefighting Fire-fighters should wear positive pressure self-contained breathing apparatus Procedures: (SCBA) and full turnout gear. Section 6 Accidental release measures Spills produce slippery surfaces. Important: Before responding to a spill or leak of this product, review each section of this MSDS. Follow the recommendations given in the Handling Precautions sections. Check the Fire and Explosion Data section to determine if the use of non-sparking tools is merited. Insure that spilled or leaked product does not come into contact with materials listed as incompatible. If irritating fumes are present, consider evacuation of enclosed areas. Initially minimize area affected by the spill or leak. Block any potential routes to water systems (e.g., sewers, streams, lakes, etc.). Based on the product's toxicological and chemical properties, and on the size and location of the spill or leak, assess the impact on contaminated environments (e.g. water systems, ground, air equipment, etc.). There are no methods available to completely eliminate any toxicity this product may have on aquatic environments. Minimize adverse effects on these environments. Determine if federal, state, and/or local release notification is required (see Regulatory Classifications section of this MSDS). Recover as much of the pure product as possible into appropriate containers. Later, determine if this recovered product can be used for its intended purpose.Address clean-up of contaminated environments. Spill or leak residuals may have to be collected and disposed of. Clay, soil, or commercially available absorbents may be used to recover any material that cannot readily be recovered as pure product. Flushing residual material to an industrial sewer, if present at the site of a spill or leak incident, may be acceptable if authorized approval is obtained. If product and/or spill/leak residuals are flushed to an industrial sewer, insure that they do not come into contact with incompatible materials. Contact the person(s) responsible for the operation of your facility's industrial sewer system prior to intentionally flushing or pumping spills or leaks of this product to the industrial sewer. Section 7 Handling and storage Handling and Storage Precautions Store in cool, dry place (0°C—350C). Keep away from heat, sparks and flame. Freezing will affect the physical condition and may damage the material. Work/Hygienic Practices: Handle in accordance with good industrial hygiene and safety practice. Incompatability Oxidizing agents may cause exothermic reactions. Section 8 Exposure controls 1 personal protection Use local exhaust if misting occurs. Natural ventilation is adequate in absense of mists. In case of insufficient ventiliation wear suitable respiratory equipment. Rubber gloves, safety glasses with side shields. Do not wear contact lenses. Chemical resistant apron or protective suit if splashing or contact with solution is likely. Wash hands before breaks and end of workday. Handle in accordance with good industrial hygiene and safety practice. Page 2 of 5