Laserfiche WebLink
D. Results of TestinglServicing <br /> Software Version Installed: 327,04 <br /> Complete the fol lowing checklist: <br /> ® Yes ❑ No" Is the audible alarm operational? <br /> E Yes ❑ NW Is the visual alarm operational? <br /> Z Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> 0 Yes ❑ No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No' If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> 0 N/A <br /> Yes ❑ No' For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a <br /> I ❑ N/A leak, fails to operate, or is electrically disconnected? If yes: --which sensors initiate positive shut-down? (Check all that apply) <br /> Sumplrrench Sensors; ®Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor fail ureldisconnection? 0 Yes; ❑No. <br /> El Yes ❑ Ne For tank systems that utilize the monitoring system as the primary tank overfill warning device(i'"e.,no mechanical overifill prevention valve is <br /> ® NIA installed), is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so, at what percent of tank <br /> capacity does the alarm trigger? 0% <br /> ❑ Yes' ® No Was any monitoring equipment replaced? If yes, identify specific sensors, probes,or other equipment replaced and list the manufacturer <br /> name and model for all replacement parts in Section E,below. <br /> ❑ Yes' ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check off that apply) <br /> ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> ® Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> 0 Yes ❑ No' Is all monitoring equipment operational per manufacturees specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. comments: inspector Stacy on site has all print outs . <br /> Monitoring System Certification Page 2 of 4 2121107 <br />