Laserfiche WebLink
D. Results of TestinglServicing <br /> Software Version installed: 17.00 <br /> om lete the following checklist: <br /> ® Yes ❑ No' Is the audible alarm operational? <br /> ❑ Yes ❑ No' Is the visual alarm operational? <br /> E Yes ❑ Ne" Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Z Yes ❑ No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No` If alarms are relayed to a remote monitoring station,is all communications equipment(e g.,modem)operational? <br /> Z NIA <br /> 9 Yes ❑ No" For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak. <br /> ❑ N/A fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut-down? (Check all that apply) ® SumplTrench <br /> Sensors; ® Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? 0 Yes; ❑No. <br /> ❑ Yes ❑ No' For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no mechanical overfill prevention valve is <br /> ® <br /> NIA installed),is the overfill warning alarm visible and audible at the tank fill points)and operating properly? If so,at what percent of tank capacity <br /> does the alarm trigger? ©% <br /> ❑ Yes ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> ❑Yes` ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> ❑ Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ® Yes ❑ No' Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments. <br /> Monitoring System Certification Page 2 of 4 2/21/07 <br />