REMOVAL_1988 - Laserfiche WebLink

Home Browse Search

' .. .. .... .e.:...: ,.. .,-.--js--r�crvur•:r+y:::a..,•.+c.n �..Murs:.r,.«.a�.+�•9++sen—.=^a+-.^n'+9+*�fiSea^^,...'^'*•—�_. SAMPLE HANDLING PROCEDURES Solid sample material is captured by advancing the liner into the soil. This may be done by pushing the liner into soft soils or by containing the liner in a drive shoe which can be advanced and then retracted by means of a slide hammer. The open ends of the sample liner are covered with aluminum foil and plastic end caps. Excess aluminum foil is removed and the edge of the plastic end cape is tightly sealed against the outer surface of the brass liner with an unbroken wrap made with a tape which has been tested to confirm that it does not contribute compounds that would be detected in the type of analyses intended for the sample contained inside of the brass liner. The brass liner is then labeled with the appropriate identification numbers which specify the sampling activity designation number, sample collection area, depth etc. that apply to that particular sample. The sample liner is then placed in an ice chest which contains pre-frozen blocks of an inert ice substitute such a Blue Ice or Super Ice. SAMPLE DESIGNATIONS All samples containers are identified with both an activity number and a discrete sample identification. Please noie that the activity number is the number that appears on our chain of custody. It is roughly equivalent to a job number, but applies only to work done on a particular day of the year rather than spanning several days as an actual activity often does. This is followed by the sample I.D. number which is usually a simple number such as #1, #2, #3: CHAIN OF CUSTODY Samples are continuously maintained in either a chilled ice chest, refrigerator, or freezer from the time of collection until acceptance by the State certified Hazardous Materials Testing Laboratory selected to perform the analytical procedures. If the samples are taken charge of by a different party (such as another person from our office, a courier, etc.) prior to being delivered to the laboratory, appropriate release and acceptance records are made on the chain of custody (time, date, and signature of person releasing the samples followed by the time, date and signature of the person accepting custody of the samples). LABORATORY IDENTIFICATION NUMBERS Following receipt of the samples and completion of the Chain of Custody form, the laboratory then assigns their own identification numbers to the samples. Different laboratories use different numbering systems and, according to their own internal conventions, may or may not assign sequential numbers to samples which are placed on temporary "hold", pending the results of other analyses. Laboratory identification numbers (if assigned and available) are included on the DIAGRAM page, and will be found on the certified analytical report by the analytical laboratory. Sampling Report 88306-M-1 AL WILLIAMSON page 5