Laserfiche WebLink
D. Results of Testing/Servicing <br /> Software Version Installed: 10.02 <br /> om lete the following checklist: <br /> 0 Yes ❑ No` Is the audible alarm operational? <br /> 0 Yes ❑ No' Is the visual alarm operational? <br /> ❑ Yes No* Were alt sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No' If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> NIA <br /> ® Yes © No` For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br /> ❑ NIA fails to operate, or is electrically disconnected? If yes': which sensors initiate positive shut-down? (Check all that apply) ® Sump/Trench <br /> Sensors; ®Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failureldisconnection? ®Yes; ❑No, <br /> ❑ Yes ❑ No" For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no mechanical overfill prevention valve is <br /> NIA instatled),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity <br /> does the alarm trigger? 0% <br /> ❑ Yes ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> []Yes, ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> 0 Product; ❑Water. If yes,describe causes in Section E,below. <br /> 0 Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ER Yes ❑ Na' Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> 89 ANNULAR SENSOR WOULD NOT CLEAR . HAD SAME NOTES FROM LAST YEAR . INSPECTOR <br /> E. comments: RAY SAID TO PUT NEW SENSOR . JOHNY CALLED WAYNE HMG WILL REPLACE AND RETEST <br /> Monitoring System Certification Page 2 of 4 2)21/07 <br />