Laserfiche WebLink
Aug-31-04 04:55pm From-Gettler-10 Inc +9166311317 It T-35T P.009/009 F-269 <br /> Dispenser Control Interface Installation Installing the Dispenser Pan Sensor <br /> l <br /> 2. Remove lower-front panels from dispenser to be modified. <br /> Important eir It may be necessary to remove both the front and rear panels of the dispenser to gain <br /> access to the junction box. <br /> 3. Remove the junction box cover and pipe plug from the appropriate junction box <br /> conduit opening.Retain cover and bolts for reassembly. <br /> 4. Insert WHITE,BLACK,AND RED wires from the dispenser control interface <br /> into the threaded opening in the junction box.Screw the interface into the junction <br /> box and tighten. See Figure I below.At least 5 full threads must be engaged <br /> between each interconnect of the conduit. <br /> POWER <br /> 120 vac <br /> NEUTRAL <br /> TO DISPENSER <br /> EXISTING EXISTING <br /> CONDUIT CONDUIT <br /> DISPENSER <br /> I-IF TO Oq- CPNTRIIL <br /> REDUCER INTERFACE <br /> ° 1I 'COUPLING <br /> 0 <br /> DISPENSER PAN <br /> SENSOR <br /> NIPPLE a e <br /> o <br /> (NOT SUPPLIED) <br /> DISPENSER PAN <br /> JUNCTION BOX <br /> Figure T. Typical Dispenser Control Interface Installation <br /> 5. For Discriminating Dispenser Pan Sensor with Dispenser Control Interface,Part <br /> Nos. 847990-002 and 847970-002,attach the CAUTION Tag to the dispenser pan <br /> in a visible area. <br /> 6: Any additional parts required to allow the interface to clear the parts adjacent to <br /> the junction box conduit opening must be provided by the installer.At least 5 full <br /> threads must be engaged between each interconnect of the conduit. <br /> CAUTION: Do not use pipe sealant or teflon tape to seal conduit <br /> interconnections. Failure to comply can result in explosion hazard. <br /> Important� Check to see that the intrinsic Safety WARNING Label is still securely attached to the <br /> cable.The labels must be attached to the cables at all times.Replace them if they are <br /> missing or the wording is not legible. See Figure 2 below; refer to Figure I for label <br /> location. <br /> 8 <br />