Laserfiche WebLink
UST SYSTEM PRINTSET INFORMATION <br />1. Four complete sets of plans (To include specification sheets and/or equipment [�bro/chures if not on file). <br />J <br />2. Plans drawn to scale in non -erasable print. ' `l bl�`th'S O Skady pe Op Tl� `l [OM <br />3. Plot plan to show Location and number of tanks. L'6il eln pffim C 4(JI ) <br />4. _✓ Tank cross-sectional diagram included on prints submitted. <br />5. Detail of tank, piping system, excavation and cover. <br />6. Tank(s) and piping approved by a nationally recognized independent testing organization. [Title 23, Subchapter 16, <br />Article 3, Sec. 2631 (r) & 26353 i /fA)K Tc) b.-- re.c.e', {-j } , e-,1 <br />7. verification of product compatibility with the tank(s), piping, monitoring <br />/ device(s), epoxy or silicone glues, etc. (Section 2635 (b) (2)] <br />8. ✓ Manufacturers written installation instructions for tank(s), piping, monitoring devices, etc. [Section 2635 (b) (5)] <br />9. Tightness Test (NFPA 30) is required on both primary (10) and secondary (20) containment systems before covering. <br />[Section 2635 (b) (6) & (7)] <br />10. Double waited tanks using pressure or vacuum testing to monitor the annular space. [Section 2635 (b) (7)) <br />11. NFPA 329 "Precision Test" required upon completion of installation with tank in operating condition. Teat results to <br />be submitted directly to PNS/END from the testing company or owner of facility. [Health & Safety Code, Division 20, <br />Chapter 6.7, Section 25291 (g)] <br />12. TANK COMPOSITION <br />TANK # <br /># I <br /># <br /># <br /># <br /># <br />CAPACITY <br />06 0 <br />MANUFACTURER <br />COMPOSITION <br />MODEL <br />PRODUCT <br />IXUlc� <br />CORROSION PROTECTION <br />I� <br />U.L. LISTED <br />J <br />COMPATIBILITY WITH 100% <br />METHANOL <br />�S <br />13. TANK(s) TO BE INSTALLED <br />A. Stee L -clad with fiberglass reinforced plastic. <br />B. Holiday test required immediately before "setting" tank(s) (35,000 - 40,000 volts). [Section 2635 (b) (4)] <br />C. Fiberglass [Sections 2635 (3) and 2631 (p)] <br />(1) Striker plate dimensions and materials. <br />(2) Striker plate under all accessible openings. <br />(3) Installation instructions require an air test and soap bubble test prior to installation. <br />D. Non -clad steel tank [Section 2635 (b)] <br />(1) Cathodic protection provided for entire tank, piping and components (nuts, bolts, washers, <br />etc.). <br />(2) Approved by a corrosion engineer or N.A.C.E. technician. <br />(3) Document stating inspection method and frequency (minimum semi-annual inspection requirement). <br />H <br />