Laserfiche WebLink
OPW 60 VS SERNS VAPOR LINE S AR VALVES <br /> The 60VS Series is similar to the OPW 60VSPC-1001 —G - <br /> 60V <br /> G 60V Series of Vapor Line Shear Valves. "Vapor Saver with <br /> They are designed to break Containment Threads" <br /> at the shear groove in the event the <br /> dispenser is dislodged,helping to pre- Same features as the 60VSP-1000 <br /> vent damage to underground piping. plus; <br /> However the 60VS Series has addition- ♦Externally threaded on outlet E <br /> al features not found in the 60V Series. end for secondary containment <br /> The 60VS Series has a 1"connection connection of underground piping <br /> at the inlet for dispenser piping and an <br /> IIA" at the outlet end to accommodate Materials <br /> 11h" underground vapor lines. An air <br /> test port is also included to give access Body:cast iron <br /> to the vapor lines without breaking Discs:M-19 + <br /> pipe joints. At the dispenser inlet end, Inlet thread size: 1"NPT infernal threads <br /> two connections are available(offering Outlet thread size: 1 SIA"internal threads <br /> a convenience of choice for installa- <br /> tions). A connection through the top of Ordering Specifications <br /> the valve or the side may be made. A Product No. Length <br /> plug is shipped with the valve in order <br /> to plug off the opening not used. 31 177 <br /> 60V5-1000 631/32" 177 c <br /> The mounting connection,below the 60VSP-1001 631/32" 177 <br /> shear groove,has three drilled and 60VSPC-1001 631/32" 177 <br /> tapped holes for mounting to a stabiliz- <br /> er bar. All 60V and 60VS models have <br /> the all important mounting connection A D • <br /> above the shear groove as well. Dimensions <br /> Mounting above the shear groove is <br /> in. mm. <br /> important on vapor lines because of the <br /> use of exible pipe above this point. A 111/32' 34 <br /> The shear section must be isolated so B 631/32' 177 <br /> that it is the weak point in the line. L 21115" 68 — <br /> D 11/2' 38 F <br /> OPW 60VS-1000 E 227/32' 73 <br /> "Line Saver" F 1'1/16' 43 <br /> Same features as the 60V-1000 plus; G 215/16' 75 B <br /> ♦ ll/Y' connection to underground <br /> piping <br /> ♦Air test port to enable vapor line <br /> testing without breaking pipe <br /> connections <br /> IF <br /> ♦Choice of top or side inlet <br /> connection <br /> ♦ Stabilizer mounting connection <br /> OPW 60VSP-1001 <br /> "Vapor Saver" <br /> Same features as the 60VS-1000 plus-, IMPORTANT. OPW products should be used in <br /> p compliance with applicable federal,state and local laws <br /> ♦ Double-poppeted design helps and regulations. Product selection should be based on <br /> s - physical specifications and limitations and compatibility • <br /> prevent vapor loss in the event the , with the environment and materials to be handled, <br /> dispenser is toppled OPW MAKES NO WARRANTY OF FITNESS <br /> FOR A PARTICULAR USE. All illustrations and <br /> specifications in this literature are based on the latest <br /> product information available at the time of publication. <br /> OPW reserves the right to make changes at any time in <br /> prices,materials,specifications and models and to <br /> discontinue models without notice or obligation. <br /> pit <br />