Laserfiche WebLink
U. I.f-j�ilts of Testing/Servicing <br />Software Version Installed: <br />!`,..�.., ko,. rh,. fnllniuinn rha,rl: list• <br />X Yes <br />❑ No* <br />Is the audible alarm operational? <br />® Yes <br />❑ No* <br />Is the visual alarm operational? <br />.6 Yes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? � <br />Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />I <br />not interfcr c with their Drover operation? <br />❑ Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />A N/A <br />operational? <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically, disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) JZ Sump/'Trench Sensors-, Dispenser Containment Sensors. <br />Did You confirm positive shut -down due to leaks and sensor failure/disconnection? 6Ycs: ❑ No. <br />❑ Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />•t N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fillpoint(s) and operating roDerly? If so, at what percent of tank capacity does the alarm trigger? % <br />❑ Yes* <br />A No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E. below. <br />❑ Yes* <br />R� No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />Product; ❑ Water. If ycs, describe causes in Section E. below. <br />Yes <br />❑ No* <br />Was monitoring systcm set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />,:ii- Yes <br />❑ No* <br />Is all monitoring c ui mcnt oocrational 2cr manufacturer's s ecifications? <br />* In Section E below, describe how and when [nese uetrctenetes were or win oe correciea. <br />E. Comments: I i�1VS >I lS I{� SQ�1 <br />