COMPLIANCE INFO 2013-2015 - Laserfiche WebLink

Home Browse Search

MONITSUNG SYSTEM CERTIFWATION CERTIFICATION /TEST DATE: January 16, 2013 Ai. FACILITY A2. OWNER Name Tower Mart # 104 Name Tower Energy Group, Inc. Address 192 Lathrop Road, Lathrop, CA 95330 Address 1983 West 190th Street, Torrance, CA 90504 Phone # 209-858-4998 Phone # 916-285-7402 eat 100 Contact Desiz Bums contact Mark Vasey ID. RESULTS OF TESTING 1 SERVICING Make 1 Model of Monitoring System: Veeder-Root TLS -350 Software Version Installed: 327.04 Complete the following checklist: ■ Yes ❑ No * Is the audible alarm ■ Yes ❑ No* Is the visual alarm c ■ Yes ❑ No * Were all sensors visually Inspected, functionally tested, and confirmed ■ Yes ❑ No * i Were all sensors Installed at lowest point of secondary containment and ositloned s *k-4 oth I F] Yes ■ Yes ■ Yes El Yes ❑ No * ■ NIA ❑ No* El NIA El No 171No* ■ NIA p o a er equ pmem will not Interfere with their proper operation? If alarms are relayed to a remote monitoring station, Is all communications equipment (e.g. modems) operational? For pressurized piping systems, does the turbine automatically shut down If the piping secondary containment monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shutdown? (check all that apply) ■ Sump/Trench sensors; ■ Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor fall uraid isconnection? For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill prevention valve Is Installed), Is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? _% ❑ Yes * ■ No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ■ Yes * ❑ No Was any liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ■ Water. If yes, describe causes In Section E, below, 0 Yes ❑ No* Was monitoring system set-up reviewed to Insure proper settings? Attach set-up reports, If applicable. ■ Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? * In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Removed liquid from the diesel STP, diesel fill, and 87-1 fill sumps. Page 2 of 3