Laserfiche WebLink
1. <br /># <br />Three complete sets o9ans <br /># <br />(include manufacturer's specification sts for proposed equipment to be instatted). <br />2.- <br />✓ <br />Plans drawn to scale in non -erasable print. <br />3. <br />✓ <br />Plot plan to show location of tanks and all associated piping. <br />4. <br />V <br />Striker plates or drop tube -mounted bottom protectors illustrated below all accessible openings. <br />5. <br />_41— <br />Tank cross-sectional diagram. <br />6. <br />✓ <br />Detail of tank, associated piping, excavation and cover. <br />7. <br />✓ <br />Tank(s) and piping approved by a nationally recognized independent testing organization. [Title 23, Chapter 16, <br />MODEL <br />Article 3, Section 2631 (b) 8 26351 <br />8. <br />V✓ <br />Verification of product compatibility with the tank(s), piping, monitoring <br />PRODUCT <br />[II <br />device(s), epoxy or silicone glues, etc. <br />9. <br />Manufacturer's written installation instructions for tank(s), piping, monitoring devices, etc. <br />10. <br />_e- <br />At the installation site, prior to installation, a tightness test shall be performed on both (10) <br />K <br />Y <br />primary and <br />secondary (2) containment systems before covering. [Section 2635 (a) (3) 8 (4)1 <br />11. <br />wL <br />Tank integrity test required upon completion of installation with tank in operating condition. Test results to be <br />submitted directly to PHS-EHD from the testing company or owner of facility. [Health 8 Safety Code, Division 20, <br />COMPATIBILITY WITH 100% <br />METHANOL <br />Chapter 6.7, Section 25291 (h)] <br />12. <br />TANK COMPOSITION <br />TANK # <br /># <br /># <br /># <br />CAPACITY <br />11noo <br />000 <br />OO <br />MANUFACTURER <br />1 <br />COMPOSITION <br />4 <br />C <br />MODEL <br />PRODUCT <br />[II <br />1­14--t— <br />/1 –f'CORROSION <br />CORROSIONPROTECTION <br />any <br />cd <br />K <br />Y <br />U.L. LISTED <br />COMPATIBILITY WITH 100% <br />METHANOL <br />13. TANK(s) TO BE INSTALLED <br />1/ A. Steel -clad with fiberglass reinforced plastic coatings, composites, or equivalent non-metallic exterior <br />coatings or coverings. <br />(1) Tested at the installation site using an electric resistance holiday detector. <br />1 (2) Vacuum applied to interstitial space. <br />B. Fiberglass <br />(1) Installation instructions require an air test and soap bubble test prior to installation. <br />(2) Vacuum applied to interstitial space. <br />(3) Hydrostatic annular (primary tank pressure test). <br />C. Non -clad steel tank [Section 2635 (a) (2) (A)1 <br />(1) Cathodic protection provided for entire tank, piping and components (nuts, bolts, washers, <br />etc.). <br />(2) Field installed cathodic protection systems designed and certified as adequate by a <br />corrosion specialist. <br />(3) Impressed current systems to be inspected no less than every 60 days. <br />