Laserfiche WebLink
Bulletin No. B2107 <br />October 1, 1993 <br />UL Listed RED THREAWR lin Pif�l, <br />SCOPE <br />PIPE -- Pipe shall be manufactured by Smith <br />Fiberglass PrOdUdS, Inc. by a filament winding <br />process using a thermosetting epoxy resin to <br />ilnpregnalr strands of continuous glass fila- <br />ments which are wound around a mandrel at a <br />prescribed helix angle and under controlled <br />tension. All pille will be supplied with match- <br />ing tapered T.A.B.'I"' (Threaded and Bonded) <br />Coupling and spigot ends or'I'.A.B. spigot x <br />Spigot ends. <br />CONSTRUCTION <br />2"-4" PIPE - RI:D TI IRFAD IIA pipe shall have <br />continuous glass fibers filament wound at a <br />35W helix angle in a matrix of epoxy resin. <br />Pipe shall Ix' in compliance with ASPM D2310 <br />and classified by its designation code. Pipe <br />Shall meet all dinx'n5ional and performance <br />requiremenls, mechanical properties, and shall <br />be classifiedWilh the following designation <br />codes: <br />Size [Designation Code at 73.4' F <br />2"-3" RTRP-11 AE <br />4" RTRP-11AF <br />ITEMS <br />2"-4" PIPE - Glass fiher reinforced filament <br />wound pipe with matching tapered'T.A.B. <br />(Threaded and Bonded) coupling and spigot <br />ends. Pipe to be factory prooftested at the fol- <br />lmving pressures: <br />2" - 37S prig <br />3" - 265 psig <br />4" - SOO prig <br />2"-4" FITTINGS - Compression lHolded fittings <br />shall be manufactured using an epoxy ,,old- <br />ing compound. The molding compound shall <br />be reinforced with a minimum of 451%I <br />chopped glass fiber. In-line fittings are fila- <br />ment wound. <br />ADHESIVES - Adhesive and curing agents shall <br />be Ul. Listed DS -8000 series adhesives. <br />Consult Smilh Piherglass Products' installation <br />manual No. 132160 for recommended heat cur- <br />ing techniques. <br />JOINING TECHNIQUES <br />2"-4" PIPE and FITTINGS - Pipe and fittings <br />shall be joined with DS -8000 series adhesive <br />using matching tapered bell/coupling and <br />spigot. Material to be installed in accordance <br />with Smith Ftherglass Products' installation <br />manual No. 132160. <br />TESTING <br />2"-4" PRIMARY PIPE SYSTEMS - Primary pipe <br />systems should be tested prior to use to assure <br />soundness of all joints and connections. <br />Consult Smith Fiberglass I'rnducts' installation <br />manual No. 132160. <br />mrmare <br />;PEI <br />'.md '"' l iadrm,mka M Smi11l I ibrn7la, Pmdm is Inc. RX opyrighl 1993 Smith Fiberglass Products Inc. <br />PRIN I1.D IN 11 SA., /. 51,11093 SMITH FIBERGLASS PRODUCTS INC. • A SUBSIDIARY OF A. O. SMITH CORPORATION <br />2700 W. 65TH ST., LITTLF ROCK, AR 72209-8592 • 501568-4010 • FAX 501 568-4465 • TWX 910722.7377 <br />