Laserfiche WebLink
Exhibit 8 <br /> Required Items in Conducting TP-201.3 <br /> (Executive Orders VR-201-D and VR-202-D) <br /> The instructions below are required when conducting TP-201.3 for these systems. The <br /> tester shall document that each step was followed as indicated below and shall include <br /> this page of the Exhibit with the submission of TP-201.3 test results. Note that districts <br /> may require use of an alternate form to meet these requirements, provided the alternate <br /> form includes the same minimum parameters. <br /> 1. Prior to conducting TP-201.3, all four ball valves on the Healy Clean Air <br /> Separator (CAS) shall be closed, as shown in Figure 1 or Figure 1 H, to isolate it <br /> from the Underground Storage Tank (UST) system to permit the pressurization <br /> of the UST system. Figure 1 applies to vertical CAS installations and Figure 1 H <br /> applies to horizontal CAS installations. <br /> 2. Conducting TP-201.3 with any dispenser piping test valve in the closed position <br /> is not permitted. Any dispenser with a dispenser piping test valve in the closed <br /> position while conducting TP-201.3 will bias the test towards compliance. <br /> 3. After conducting TP-201.3, the four ball valves on the Healy Clean Air Separator <br /> (CAS) shall be locked in their normal operating positions as shown in <br /> Figure 213-2 or 213-2H, Exhibit 2 of Executive Orders VR-201-D and VR-202-D. <br /> Figure 28-2 applies to vertical CAS installations and Figure 2B-2H applies to <br /> horizontal CAS installations. <br /> Required Steps Verification <br /> (please circle) <br /> 1. All four CAS ball valves closed before conducting TP-201.3 Yes No <br /> 2. All dispenser piping test valves open before conducting Yes No <br /> TP-201.3 <br /> 3. All four CAS ball valves in normal operating positions after Yes No <br /> conducting TP-201.3. <br /> Test Company: Facility Name: <br /> Print Name (Technician) Signature Date <br /> Technician Certification Number and Expiration Date <br /> (ICC or District Training Certification, as applicable) <br /> Items Required in Conducting TP-201.3, Exhibit 8 — ExeClktive Orders VR-201-D and VR-202-D <br />