Laserfiche WebLink
lJ <br />9 <br />San Joaquin County <br />Environmental Health Department <br />600 East Main Street <br />Stockton, California 95202-3029 <br />August 21, 2007 <br />Website: www.sjgovorg/ehd <br />Phone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />Sacramento Equipment Maintenance Company <br />2533 Connie Drive <br />Sacramento, CA 95815 <br />Attn: Linda Steiger <br />Re: 4943 S State Route 99, CA 95206 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />The San Joaquin County Environmental Health Department (EHD) has completed the <br />review of the application for permit to install a Pressure line leak detector at the above <br />noted address. The permit has been approved with the following conditions: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution. <br />Control District for any applicable permits and requirements. <br />2. Contact Muniappa Naidu at (209) 468-3439 to arrange the following inspection <br />appointment (a 48-hour notice is required for inspection appointments): <br />a. Functionality test <br />3. Any changes in information and scope of work must be submitted to EHD for <br />approval prior to commencing work. All new addenda supersede the previous <br />ones. <br />4. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all <br />of the following: <br />a. One of several permissible valid, current contractor's licenses issued by <br />the Contractors State License Board (may be issued to the installation <br />company), and <br />b. A valid, current California UST Service Technician certificate issued by <br />the International Code Council (ICC), and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced. <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />5. Complete and submit a copy of a UST Installation Certificate of Compliance <br />(Former Form C) to this office no later than 30 days after work is completed. <br />