Laserfiche WebLink
X/ D. Alternate construction for new underground storage tanks contai# motor vehicles fuel [Section 26331. <br /> (1) Monitoring and response plan [Section 26341. <br /> /(2) Underground storage tank composed of.... <br /> (a) Fiberglass reinforced plastic. <br /> _ (b) Cathodically protected steel. <br /> (c) Steel clad with fiberglass reinforced plastic. <br /> (d) Other material that complies with section 2631 and 2632. <br /> _ (3) Floor of Leak interception and detection system constructed on a firm base and sloped to a <br /> collection sump (use of membrane liners comply with section 2631 (d) (6) requirements.) <br /> _ (4) Access casings installed in the collection sump of the secondary containment system with <br /> backfill in the interstitial space. The access casing shall meet all of the following: <br /> Designed and installed to allow the Liquid to flow into the casing. <br /> _ Sized to allow removal of collected liquid and able to withstand all anticipated applied <br /> stresses. <br /> Constructed of material that will not be structurally weakened. <br /> Screened along entire vertical zone of permeable material. <br /> Capable of preventing Leakage of any hazardous substance from the casing. <br /> Extend to the ground surface and covered with a locked waterproof cap. <br /> Capable of meeting S.J. Co. PHS-EMD Well Standards. <br /> Leak interception and detection system shall prevent the leaked hazardous substance from <br /> entering ground water. <br /> 14. INTERSTITIAL SPACE MONITORING <br /> A. Visual monitoring [Section 2632 (c) (1)] <br /> _ (a) Exterior surface and floor beneath tank monitored by direct viewing <br /> _✓ (b) Daily visual inspections <br /> (c) Liquid level in tank to be recorded at time of inspection <br /> >/ (d) If liquid observed around or beneath primary tank, owner will determine if an unauthorized release <br /> has occurred. <br /> B. Mechanical or electronic monitoring [Section 2632 (c) (2)] <br /> (a) Continuous monitoring system connected to an audible and visual alarm system. <br /> Monitoring equipment to be installed <br /> _✓ Manufacturer: �nAcL— <br /> V/ Model Number: CIT rl y.vL.U <br /> Sensor Type: _ Vapor 1ZLiquid _ Both. <br /> -1/11, <br /> Sensor/Panel specifications. <br /> Location(s) for se ors: <br /> Tank: ✓ Piping: <br /> Dispenser: <br /> C. Monitoring and response plan submitted [Section 2632 (d) (1) & (2)]. <br /> 15. Any special accessories, fittings, coatings, or linings not inherent within the initial design of the 1° tank or <br /> double-wall UST. [Section 2631 (b)]- A. Approved by a nationally recognized independent testing organization. <br /> ✓✓✓/ B. Demonstration of integrity with the primary and/or secondary containment. <br /> 6 <br />