COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

140-0514 • •the unnary system •the cardiovascular system •the reproductive system SIGNS AND SYMPTOMS OF OVEREXPOSURE Headache, dizziness,nausea,and loss of coordination are indications of excessive exposure to vapors or spray mists. Redness and itching or burning sensation may indicate eye or excessive skin exposure. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE None generally recognized. CANCER INFORMATION For complete discussion of toxicology data refer to Section 11. SECTION 4-FIRST AID MEASURES EYES: Flush eyes with large amounts of water for 15 minutes.Get medical attention. SKIN: Wash affected area thoroughly with soap and water. Remove contaminated clothing and launder before re-use. INHALATION: If affected, remove from exposure. Restore breathing. Keep warm and quiet. INGESTION: Do not induce vomiting.Get medical attention immediately. SECTIONS-FIRE FIGHTING MEASURES FLASH POINT LEL UEL EXTINGUISHING MEDIA Propellant<0°F 1.0 12.8 Carbon Dioxide, Dry Chemical,Foam UNUSUAL FIRE AND EXPLOSION HAZARDS Containers may explode when exposed to extreme heat. Application to hot surfaces requires special precautions. During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms may not be immediately apparent. Obtain medical attention. SPECIAL FIRE FIGHTING PROCEDURES Full protective equipment including self-contained breathing apparatus should be used. Water spray may be ineffective. If water is used,fog nozzles are preferable.Water may be used to cool closed containers to prevent pressure build-up and possible autagnition or explosion when exposed to extreme heat. SECTION,6-ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED •Remove all sources of ignition. Ventilate the area •Remove with inert absorbent. SECTION-7-HANDLINGAND STORAGE STORAGECATEGORY Not Available PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Keep away from heat,sparks, and open flame.Vapors will accumulate readily and may ignite explosively. During use and until all vapors are gone: Keep area ventilated-Do not smoke-Extinguish all flames, pilot lights,and heaters-Turn off stoves, electric tools and appliances, and any other sources of ignition. Consult NFPA Code. Use approved Bonding and Grounding procedures. Contents under pressure. Do not puncture,incinerate, or expose to temperature above 120F.Heat from sunlight, radiators,stoves, hot water, and other heat sources could cause container to burst. Do not take internally. Keep cut of the reach of children. SECTION 8- EXPOSURE CONTROLS/PERSONAL PROTECTION PRECAUTIONS TO BE TAKEN IN USE Use only with adequate ventilation. Avoid contact with skin and eyes. Avoid breathing vapor and spray mist. Wash hands after using. This coating may contain materials classified as nuisance particulates(listed"as Dust"in Section 2)which may be present at hazardous levels only during sanding or abrading of the dried film. It no specific dusts are listed in Section 2,the applicable limits for nuisance dusts are ACGIH TLV 10 mg/m3(total dust),3 mg1m3(respirable fraction),OSHA PEL 15 mg/m3(total dust),5 mg1m3(respirable fraction). VENTILATION Local exhaust preferable.General exhaust acceptable if the exposure to matenals in Section 2 is maintained below applicable exposure limits. Refer to OSHA Standards 1910.94, 1910.107, 1910.108. RESPIRATORY PROTECTION If personal exposure cannot be controlled below applicable limits by ventilation,wear a properly fitted organic vapor/particulate respirator approved by NIOSWMSHA for protection against materials in Section 2. When sanding or abrading the dried film, wear a dust/mist respirator approved by NIOSH/MSHA for dust which may be generated from this product,underlying paint,or the abrasive. page 2 of 4