COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

REGENEU 192015 PPG Industries,Inc. One PPG Place Al Pittsburgh,PA 15272 L UNUSUAL FIRE AND EXPLOSION HAZARDS: OSHA,Ontario or PPG,they will be listed below. These limits are Keep this product away from heat,sparks,flame,and other sources of intended for use in the practice of industrial hygiene as guidelines or ignition(i.e.,pilot lights,electric motors,static electricity).Invisible vapors recommendations in the control of potential workplace health hazards. can travel to a source of ignition and flash back. Do not smoke while These limits are not a relative index of toxicity and should not be used by using this product.Keep containers tightly closed when not in use.Closed anyone without industrial hygiene training. containers may explode when overheated. Do not apply to hot surfaces. Toxic gases may form when this product comes in contact with extreme Material/ Percent ACGIH TLV ACGIH OSHA PEL STEL heat.May produce hazardous decomposition products when exposed to CAS Number STELNot extreme heat.Extreme heat includes,but is not limited to,flame cutting, NAPHTHA 60-100 100 ppm established 100 ppm established brazing,and welding. PARAFFIN 1-3 W PARAFFIN WAXES 1-5 2 MG/m3 established 2 mg/m3 established AND SECTION 6-ACCIDENTAL RELEASE MEASURE HYDROCARBON STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: WAXES Provide maximum ventilation.Only personnel equipped with proper 8002-74-2 respiratory,skin,and eye protection should be permitted in the area. Remove all sources of ignition. Take up spilled material with sand, Material/ Percent Ontario Ontario PPG IPEL PPG STEL vermiculite,or other noncombustible absorbent material and place in CAS Number TWA STEL clean,empty containers for disposal. Only the spilled material and the NAPHTHA 60-100 525 MG/m3 Not Not Not absorbant should be placed in this container. 8052-41-3 established established established PARAFFIN WAXES 1-5 2 MG/m3 Not Nt established estabfshed established SECTION 7-HANDLING AND STORAGE AND HYDROCARBON PRECAUTIONS TO BE TAKEN DURING HANDLING AND STORAGE: WAXES Vapors may collect in low areas. If this material is part of a multiple 8002-74-2 component system,read the Material Safety Data Sheet(s)for the other component or components before blending as the resulting mixture may have the hazards of all of its parts.Containers should be grounded when Key:ACGIH=American Conference of Governmental Industrial pouring. Avoid free fall of liquids in excess of a few inches. Hygienists;OSHA=Occupational Safety and Health Administration; STORAGE: TLV=Threshold Limit Value;TWA=Time Weighted Average; Do not store above 120 degrees F.(48 degrees C.).Store large quantities PEL=Permissible Exposure Limit(1989 Vacated values);IPEL=Internal in buildings designed and protected for storage of NFPA Class II Permissible Exposure Limit;Ceiling=TLV or PEL Ceiling Limit;STEL=TLV combustible liquids. or PEL Short-Term Exposure Limit;Skin=Skin Absorption Designation. [C-Ceiling Limit;S-Potential Skin Absorption;R-Respirable Dust] SECTION 8 EXPOSURE CONTROLS&PERSONAL PROTECTION Additional Information Not applicable. ENGINEERING CONTROLS: Provide general dilution or local exhaust ventilation in volume and pattern SECTION 9-PHYSICAL&CHEMICAL PROPERTI to keep the concentration of ingredients listed in Section 8 below the (FORMULA VALUES,NOT S88 ES SPECIFICATIONS) lowest suggested exposure limits,the LEL below the stated limit,and to SPECIFIC GRAVITY: .7uid remove decomposition products during welding or flame cutting. PHYSICAL STATE: 4 Percent Solids: 24.36 Percent Volatile by Volume: 77.160 PERSONAL PROTECTIVE EQUIPMENT pH: Not available. EYES: ODOR THRESHOLD: Not available. Wear chemical-type splash goggles and full face shield when possibility Vapour Pressure: N.A. mmHg exists for eye contact due to splashing or spraying liquid,airborne ODOR/APPEARANCE: Viscous liquid with an odor particles,or vapors. characteristic of the solvents listed in SKIN/GLOVES: Section 2. Wear protective clothing to prevent skin contact. Apron and gloves VAPOR DENSITY: HEAVIER THAN AIR should be constructed of:neoprene rubber or nitrile rubber.No specific Evaporation Rate: 70 permeation/degradation testing have been done on protective clothing for BOILING POINT OR RANGE: 300-410Degrees F this product.Recommendations for skin protection are based on Freezing Point or Range: Not Applicable. infrequent contact with this product. For frequent contact or total Melting Point or Range(°C): Not Applicable. immersion,contact a manufacturer of protective clothing for appropriate Partition coefficient(n- Not Applicable. chemical impervious equipment.Clean contaminated clothing and shoes. octanol/water): RESPIRATOR: WEIGHT PER GALLON: 6.57(U.S.)/ 7.8(IMPERIAL) Overexposure to vapors may be prevented by ensuring proper ventilation controls,vapor exhaust or fresh air entry.A NIOSH-approved air purifying respirator with the appropriate chemical cartridges or a positive- SECTION 10-STABILITY AND REACTIVITY pressure,air-supplied respirator may also reduce exposure.Read the STABILITY: respirator manufacturer's instructions and literature carefully to determine This product is normally stable and will not undergo hazardous reactions. the type of airborne contaminants against which the respirator is effective, CONDITIONS TO AVOID: its limitations,and how it is to be properly fitted and used.Provide general None Known. dilution or local exhaust ventilation in volume and pattern to keep the INCOMPATIBLE MATERIALS: concentration of ingredients listed in Section 2 below the lowest Avoid contact with strong alkalies,strong mineral acids,or strong suggested exposure limits,the LEL below the stated limit,and to remove oxidizing agents. decomposition products during welding or flame cutting. HAZARDOUS POLYMERIZATION: GENERAL HYGIENE-ESTABLISHED EXPOSURE LIMITS None Known. If Threshold Limit Values(TLVs)have been established by ACGIH, Page 2 of 4