Laserfiche WebLink
cal - upon forum guidance <br />®W <br />Title 22, 66265.192(k)(I)--Adrawingafthe tank(s) configuraii s as well as <br />description of the materials of construction and gross capacity is included <br />(k)(2)—Design standards, if available, for the tanks and ancillary equipment, as <br />well as the following: <br />(A) --The material of construction <br />(� thickness <br />(C) --Description of tank system piping (material, diameter) <br />(D) --Description of any internal and external pumps <br />(Cs�--sketch of drawing of tank(4 including dimensions <br />(k)(3)--Docuinented (or estimated, if unknown) age of the tank system - <br />(k)(4) --Description and evaluation of any leak detection equipment <br />(Not applicable if the tank system and associated piping is to be inspected <br />daily for leaks and corrosion) <br />(k)(5) --Description and evaluation of any corrosion protection <br />equipment, devices of materials <br />(k)(6) --Description and evaluation of any spill prevention or overfill equipment <br />(k)(7) --Description and evaluation of the secondary containment <br />for the tank system (including ancillary equipment) 6 <br />(k)(8) --Hazardous waste characteristics of the waste(s) that have <br />been or will be handled is included <br />(k)(9) --independent, qualified professional engineer's inspection of the system <br />for the following; <br />(A) Weld cracks or breaks <br />(B) Scrapes of protective coatings <br />(C) Corrosion <br />(D) Any structural damage or inadequacy construction or <br />installation cracks, punctures damaged fittings. All discrepancies shall <br />be documented in the assessment and remedied before <br />the tank system is placed in use <br />k(10) --All nzm6Wtaks and ancillary equipment s11i1,I1 g trctar or <br />tightness prior4o,being.p4zcedisuse. The be <br />documented in this assessment <br />k(l I) --Estimated remaining service life of the tank system based on <br />findings of subsections k(I) through k(10) <br />e The secondary containment must be meet minimum standards as specified in subsections 0)(1) through 0)(3) of <br />this section including applicable secondary containment for ancillary equipment as required in subsection <br />66265.193(f). <br />15 <br />