COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

cal -cu forl][11 guidance B) Type and degree of external corrosion that are needed consisting of one or more of the following: 1. Corrosion -resistant materials (i.e. fiberglass) 2. Corrosion -resistant coating with cathodic protection 3. Electrical isolation devices (a)(4)-- Not Applicable if this is an above ground tank system. (a)(5)-44esign-considerations to enst" LijU: A) Tank foundations will maintain the load of a full tank B) Tank systems will be anchored to prevent)1p"on or dislodgement where the tank system is placed in -asatttvAmod zon Gated within a.seismic fault zone C) Tank systems will withstand the effects of frost heave Title 22, 66265.192(b)(1-6) --Independent, qualified professional engineer's inspection for the presence of the following after installation; 1) Weld breaks 2) Punctures 3) Cracks 4) Corrosion 5) Other structural damage Title 22, 66265.192(c) -- Not Applicable if this is an above ground tank system Title 22, 66265.192(d) -- All new tanks and ancillary equipment shall be tested for tightness prior to being placed in use Title 22, 66265.192(e) --Ancillary equipment shall be supported and protected against physical damage and excessive stress due to settlement, vibration, expansion or contraction Title 22, 66265.192(f) --If applicable, provide the type and degree of corrosion protection necessary. Independent corrosion protection specialist oversight _ Title 22, 66265.192(h)(1-2) --On ground or above ground tank systems authorized tinder PBR or CA shall have an assessment based on 66265.192(k) is on file at the facility s This evaluation may require a cross check to other tanks or systems at a facility that are on a different certification schedule. This may be information that an owner or operator, rather than the certifying engineer, should provide. 14