Laserfiche WebLink
Monitoring System Certification • • <br />D. Results of Testing/Servicing <br />Software Version Installed: <br />Com Iete the following checklist: <br />® Yes <br />❑ No* <br />Is the audible alarm operational? <br />® Yes <br />❑ No* <br />Is the visual alarm operational? <br />® Yes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />® Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other <br />equipment <br />wAI rwt interfere with their proper operation? <br />❑ Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) <br />® N/A <br />operational? <br />® Yes <br />❑ No* <br />ry containment <br />For pressurized piping systems, does the turbine automatically shut down if the piping sejat <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: sensors initiate <br />positive shutdown? (Check all that apply) ® Sump/Trench Sensors; ❑ Dispenser Contnt Sensors. <br />Did you confirm positive shutdown due to leaks and sensor failureldisconnection? ® YeNo. <br />No <br />❑ Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warevice (i.e., no <br />19 N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible an <br />at the tankfill <br />point(s) and operating properly? If so, at what percent of tank capacity does the alarmr? %❑ <br />Yes* <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, er equipmentreplaced <br />and list the manufacturer name and model for all replacement parts in Section E,.❑ <br />Yes* <br />E No <br />Was Liquid found inside any secondary containment systems designed as dry systems? (Cll that apply)❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />® Yes <br />❑ No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, icable <br />® Yes <br />❑ No* I <br />Is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe tow and when these deficiencies were or will he corrected. <br />E. Comments: All sensors pass testing All floats & Chains pass testing <br />Page 2 of 3 <br />