Laserfiche WebLink
Mar .24. 2005. 10:11AM Wr ^ht Environmental 832-5152 — No-8048 P. 11 <br /> 0 , .o. 1916:. .LL r ARPER r.un 11 <br /> Dimensions and tolerances Pipe dimensions <br /> Pipe shall be manufactured to steel pipe outside diameters for all sizes, Pipe <br /> outside diameter tolerances shall not exceed f 1 percent. <br /> Wall thickness <br /> The total wall thickness of pipe furnished under this specification shall not at <br /> any point be greater than 120 percent nor less than 671/2 percent of the <br /> nominal thickness. <br /> Fittings dimensions <br /> All fittings supplied under this specification shall have face-lo-face dimensions <br /> and laying lengths as specified in the manufacturer's literature. <br /> Physical and mechanical ASTM classification <br /> property requirements Pipe$hall conform to ASTM D2310 standard classification RTRP-11 CZ and <br /> ASTM 02996 specification designation RTRP-11 CZ 5430. <br /> Minimum ASTM <br /> Property Unite _.� _Value" Method <br /> Tensile strength <br /> Longitudinal 103 psi 32.5 02105 <br /> MPa 224 <br /> Circumferential IDS psi �.0 01599 <br /> Mpa Tensile modulus <br /> Longitudinal 10°p"i2.8 02105 <br /> apa 19.3 <br /> Clrcumfersntial 100 <br /> 0psiGPa 27,6 <br /> Compressive strength 1 W Rai 32 5 OMLongitudinal <br /> MPa 224 <br /> Compressive modulus <br /> Longitudinal 1011 psi 2.8 D696 <br /> GPa 12.3 <br /> Long,term hydrostatic design basis <br /> Slatic toopsi 31 5 02992(8) <br /> MPa 217 <br /> Thermal expansion 9 V., D696 <br /> Linear 10-111o/IV5 <br /> 10-Bmrdmm/°C 162'• <br /> Stiffness factor" D2412 <br /> (in) (mm) (I6•in3/lr1� (N m) <br /> 2 50 46 5.1 <br /> 3 80 65 7.3 <br /> 4 10D 55 6.2 <br /> 6 160 250 29 <br /> 'Resod on structural wan thickness. <br /> Maximum value. <br /> At 5%diametric deflection and room temperature. <br /> Joining methods Tapered bell x spigot adhesive joints <br /> Pipe and fittings shall be joined by means of a matching tapered adhesive <br /> joint.Adhesive for joining components shall be compatible with all Intended <br /> fluids.Adhesive system shall be used according to manufacturer's <br /> recommendations. <br /> Adapters and crossovers <br /> The following adapters and crossovers shall be provided as require& <br /> Threaded adapter: bell x male <br /> Threaded adapter: bellx female <br /> Threaded adapter: spigot x male <br /> Threaded adapter: spigot x female <br /> Flanges <br /> Flanges shall be two piece(Van Stone)type provided with raised grooves on <br /> the sealing face. Fiberglass reinforced stub ends are to be adhesive bonded to <br /> the pipe or fitting. <br />