Laserfiche WebLink
D. Results of Test!nglServicing <br /> Software Version Installed: 329.01 <br /> Complete the following checkllst: <br /> ® Yes ❑ No* Is the audible alarm operational? <br /> ® Yes ❑ No* Is the visual alarm operational? <br /> ® Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> ® NIA <br /> ® Yes ❑ No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br /> ❑ NIA fails to operate, or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check all that apply) ® Sump/Trench <br /> Sensors; ❑Dispenser Containment Sensors, <br /> Did you confirm positive shut-down due to leaks and sensor failureldisconnection? ®Yes; ❑No. <br /> © Yes ❑ No* For lank systems that utilize the monitoring system as the primary tank overfill warning device(i.e., no mechanical overfill prevention valve is <br /> ® NIA installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity <br /> does the alarm trigger? % <br /> ® Yes ❑ No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> ❑Yes' ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product; ❑Water. if yes,describe causes in Section E,below. <br /> ® Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ® Yes ❑ No* Is all monitoring equipment operational per manufacturers specifications? <br /> *in Section E below,describe how and when these deficiencies were or will be corrected. <br /> JOHN WITH EH ON SITE . REPLACED 87 ANN SPACE SENSOR . ALSO ADJUSTED CHAINS ON <br /> E. comments: DISP 5-6 AND 7-8 87 PRODUCTS <br /> Monitoring System Certification Page 2 of 4 2/21107 <br /> i <br />(I <br /> i <br /> i <br />{{E <br />