Laserfiche WebLink
San Joaquin County <br />Environmental Health Department <br />600 East Main Street <br />k Stockton, California 95202-3029 <br />CrFO Rei <br />P Website: www.sigov.org/ehd <br />Phone: (209) 468-3420 <br />September 13, 2007 Fax: (209) 464-0138 <br />HMC — Henderson Maintenance Co. <br />P.O. Box 31325 <br />Stockton, CA 95213 <br />Re: USA Gas Station #68222, 2132 Mariposa Rd., Stockton CA <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />The permit (SR0051856) to reprogram the monitoring panel at the above referenced site has been <br />approved with the following conditions. <br />Conditions of approval: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution Control <br />District for any applicable permits. <br />2. Any changes shall be submitted to the San Joaquin County Environmental Health <br />Department (EHD) for approval prior to commencing work. All new addendums <br />supercede the previous ones. <br />3. All components must be certified by an independent testing organization and labeled as <br />required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See California Code of <br />Regulations (CCR), Title 23 Chapter 16 Table B for complete list). The component must <br />bear the appropriate mark as required by the independent testing organization. <br />4. Each person installing or testing any component must hold a certificate of training from <br />the manufacturer of that component. <br />5. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all of the <br />following: <br />a. One of several permissible valid, current contractor's licenses issued by the <br />Contractors State License Board (may be issued to the installation company), and <br />b. All valid, current California UST certificates issued by the International Code <br />Council (ICC), that are applicable to the work being performed, and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced. <br />6. Before the alarm history is cleared, a current printout must be created and available for <br />EHD inspection. Inspection may occur during the functionality test. <br />7. Contact Ray von Flue (468-9848) to arrange the following inspections (a 48-hour notice <br />is required): EHD must witness the functionality of the monitoring system to ensure that <br />monitoring has been restored to meet the requirements of California Code of Regulations <br />Title 23 and the Health & Safety Code. <br />8. The monitoring must satisfy this facilities approved monitoring program. <br />