COMPLIANCE INFO 2003 - 2007 - Laserfiche WebLink

Home Browse Search

I_3 General .. This manual contains procedures to install a TCP/IP Interface Module into the following consoles: • Veeder-Root TLS-3XX consoles • Red Jacket ProPlus and ProMax consoles If this is a new installation or if site preparation is necessary, refer to the console's Site Preparation and Installation manual, or contact your Veeder-Root representative for assistance. TCP/IP Interface Requirements Minimum system requirements for TCP/IP Interface Module operation are listed below: • Console system software: Version 15 or higher - Version 21 or higher is recommended. • Network connection to a PC requires a hub. Connecting to a hub requires a straight CAT 5 cable. • Direct connection to a laptop requires an ethernet crossover cable. Connection to a LAN or WAN. Knowledge of networking. TCP/IP Kits • TLS-300/ProPlus console kit (P/N 330020-424): - TCP/IP module (P/N 331871-001) - #4-40 x 0.312" taptite screw - T-10 Torx drive (P/N 510500-414) - Installation Guide (P/N 577013-776) • TLS-350/ProMax console kit (P/N 330020-425): TCP/IP module (P/N 331870-001) Wiring harness (P/N 330584-001) Installation guide (P/N 577013-776) Contractor Certification Requirements Veeder-Root requires the following minimum training certifications for contractors who will install and setup the equipment discussed in this manual: Level 1 Contractors holding valid Level 1 Certification are approved to perform wiring and conduit routing, equipment mounting, probe and sensor installation, tank and line preparation, and line leak detector installation. Level 2/3 Contractors holding valid Level 2 or 3 Certifications are approved to perform installation checkout, startup, programming and operations training, troubleshooting and servicing for all Veeder-Root Tank Monitoring Systems, including Line Leak Detection and associated accessories. Warranty Registrations may only be submitted by selected Distributors.