Laserfiche WebLink
San Joaquin County DIRECTOR <br /> Donna Heran, REHS <br /> pPp U.Iry C Environmental Health Department <br /> p ASSISTANT DIRECTOR <br /> e —± 600 East Main Street Laurie Cotulla,REHS <br /> Stockton, California 95202-3029 PROGRAM COORDINATORS <br /> Carl Borgman,REHS <br /> Mike Huggins,REHS,RDI <br /> • c .. P Website: www.sjgov.org/ehd Margaret Lagorio,REHS <br /> 4(ikbRc <br /> Phone: (209) 468-3420 Robert McClellon, REHS <br /> Fax: (209) 464-0138 Jeff Carruesco,REHS, RDI <br /> Kasey Foley,REHS <br /> December 17, 2007 <br /> Elite IV Contractors <br /> 2535 Wigwam Drive <br /> Stockton, CA 95205 <br /> Attn: Salle Elliott <br /> Re: 16470 Cambridge Avenue, Lathrop, CA 95330 SR0052900 <br /> The San Joaquin County Environmental Health Department(EHD) has completed the <br /> review of the application for permit to install Dual Stage Annular sensor on the 87 Tank <br /> at the above noted address. The permit has been approved with the following conditions: <br /> 1. Contact the local fire department and the San Joaquin Valley Air Pollution <br /> Control District for any applicable permits and requirements. <br /> 2. Contact Muniappa Naidu at(209)468-3439 to arrange the following inspection <br /> appointment(a 48-hour notice is required for inspection appointments): <br /> a. Functionality test <br /> 3. Any changes in information and scope of work must be submitted to EHD for <br /> approval prior to commencing work. All new addenda supersede the previous <br /> ones. <br /> 4. Qualified service technicians must possess or work under the direct and personal <br /> supervision of an individual physically present at the work site who possesses all <br /> of the following: <br /> a. One of several permissible valid, current contractor's licenses issued by <br /> the Contractors State License Board(may be issued to the installation <br /> company), and <br /> b. A valid, current California UST Service Technician certificate issued by <br /> the International Code Council (ICC), and <br /> c. A valid, current certificate of training from the manufacturer(s) of the <br /> component(s)being tested,repaired, or serviced, <br /> And <br /> d. Each person installing or testing any component must hold a certificate of <br /> training from the manufacturer of that component. <br /> 5. Complete and submit a copy of a UST Installation Certificate of Compliance <br /> (Former Form C) to this office no later than 30 days after work is completed. <br />