Laserfiche WebLink
Installing the Dispenser Pan Installation Procedures <br /> Shielded ;able is required when PVC or unbonded conduit is used. <br /> To instaii the Non-Discriminating Solid-State Dispenser Pan Sensor: <br /> WARNING <br /> This device is installed in equipment where potentially lethal <br /> voltages may exist. <br /> Electri.^ai shock resulting in serious injury ar death may result if <br /> power ;s on during installation and the device is improperly <br /> installeu. <br /> 14 Before installing this device, turn off power to the system. <br /> IMPORTANT m' Do not ins:all the non-discriminating solid-state dispenser pan sensor <br /> if there is any liquid in the dispenser pan. Failure to comply can result <br /> in equiprnfmt damage or undetected potential environmental and <br /> health hazards. <br /> 1. Turn OF'F power to the EMCT« or EMCTm wi t.a BIR system. <br /> ® ® 2. Make -ure no liquid is present in the dispene er pan. <br /> IMPORTANT Before removing an existing dispenser pan sensor be sure to mark <br /> field wires in the junction box to maintain correct censor wiring polarity <br /> during the replacement procedure. <br /> 3. Choos-- a location in the dispenser pan where the sensor can be <br /> pulled straight out for future service or replacement, and the <br /> sensor ,ill rest in the cup or the lowest point of the pan. <br /> Refer to one of the following figures, whichever most resembles <br /> your installation: <br /> ❑ Filnu•e 1: "Typical Non-Discriminating Slid-State <br /> Dispenser Pan Sensor Installation," on page 6. <br /> ❑ Fi€,ure 2: "Typical Non-DLicriminating Slid-State <br /> Disl enser Pan Sensor Installation for Backfilled Pans," on <br /> pap-, 7. <br /> t <br /> MDE3136 <br /> 5 <br />