Laserfiche WebLink
Installation Procedures Installing the Dispenser Pan <br /> BRACKET <br /> CABLE <br /> 8 8 U`CPo NEL <br /> 0 O <br /> SCREEN <br /> PRODUCT (RECOMMENDED <br /> LINE FOR BACKFILLED <br /> SUMPS) <br /> DISPENSER <br /> SUMP <br /> SENSOR <br /> 0 <br /> Figure 4, Typical Non-Discriminating Solid-State Dispenser Pan <br /> Sensor Installation in a Backfilled Dispenser <br /> Containment Sump <br /> NOTE: If this is an existing installation, where mounting hardware <br /> is already in place, and only the Solid-State Dispenser Pan Sensor is <br /> being replaced, omit the following step and proceed to Step 5. <br /> 4. Install the mounting hardware according to the instructions <br /> provided with the Universal Mounting Kit. <br /> 5. Slid ; the sensor into the mounting brackec and secure in <br /> position. <br /> 6. On the junction box, install the Cord Grip supplied with wiring <br /> kit. <br /> i I 7. Feed the cable through the cord grip on the junction box. <br /> 8. Tighten the cord grip nut to ensure a watertight seal at the <br /> cable entry. <br /> 9. Using wire nuts, connect the two-wire cable to the field wires in <br /> the sensor junction box. Be sure to observe color codes to <br /> maintain proper polarity hookup with the Type A Interface <br /> Module in the EMC console. Refer to Figure 5. <br /> 8 MDE3136 <br />