Laserfiche WebLink
0 <br />D. Results of Testing/Servicing <br />Software Version Installed'. <br />:oro late the following checklist: <br />If <br />X Yes <br />❑ No' <br />Is me audible alarm operational! <br />X Yee <br />❑ Na' <br />Is Me visual alarm operational? <br />X Yes <br />❑ No' <br />Were all sensors visually inspectetl,NncGonally tested, and mnfinnad operational? <br />X Yes <br />❑ No' <br />Were all sensors installed at lowest point of secondary containment and positoned so Net other equipment will not interfere with their proper <br />operation? <br />❑ Yes <br />❑ No' <br />If alarms are relayed to a remote monitoring station, is all mmmunimlions equipment (e.g., madam) operational? <br />X WA <br />X Yes <br />❑ NW <br />For pressurized piping systems, does Me turbine auametimlly shut down If to piping semnaery containment monitoring system detects a leek, <br />❑ WA <br />fails a operate, or Is elecbimlly disconnected? If yes:+Wch sensore inittalepositive shut -down'!_ Check all that appyG X SEmp/rranrh_ <br />San...; %Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor faliureldisconnectan? X Yes; ❑ Nom _ _ _ _ <br />❑ No' <br />__ _Yes <br />For tank systems that utilize Ne monitoring system as the primary tank ovefill warning device (i. e., no meverfill prevention valve isX <br />WA <br />installed), Is the overfill warning alarm visible ant audible at the tank fill panels) end operating propedy? If st percent of rink mpadtydons <br />the alarm bigger? % <br />X No <br />Was any monitoring equipment replaced? If yes, identify spedfic sensors, probes, or other equipment replast the manufacturer name <br />and model for all replacement parts in Section E, below. <br />Yes <br />:and <br />❑ <br />X No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Chock all that apply) <br />❑ Product; ❑ Water. If yes, describe muses in Season E, below. <br />Yes <br />X Yes <br />❑ No' <br />Was animating system set-up reviewed to ensure proper settings? Attach set up reports, d applicable <br />X Yes <br />❑ No- <br />Is all monitoring equipment operational per manufacturers specifications? <br />In Section E below, describe how and when these deficiencies were or will be connected, <br />E. Comments: <br />Monitoring System Certification Page 2 of 0 2/21/07 <br />