Laserfiche WebLink
0 0 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 1.01 <br /> Complete the following checklist: <br /> N Yes ❑No* Is the audible alarm operational? <br /> N Yes ❑No* Is the visual alarm operational? <br /> N Yes ❑No* Were all sensors visually inspected,functionally tested, and confirmed operational? <br /> N Yes ❑No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> N Yes <br /> F1 No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> ❑N/A operational? <br /> For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> N Yes <br /> El No* monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> ❑N/A positive shut down? (Check all that apply) N Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut down due to leaks and sensor failure/disconnection? N Yes; ❑No. <br /> ❑No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> El Yes ®NIA mechanical overfill prevention valve is installed), is the over-fill warning alarm visible and audible at the tank <br /> fillpoint(s)and operating ro erl ? If yes,at what percent of tank capacity does the alarm trigger? <br /> ❑Yes* N No Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑Yes* N No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑ Product; ❑ Water. If yes, describe causes in Section E,below. <br /> N Yes ❑No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> N Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> REPLACED BRAVO FLOAT CHAIN ON 87 DISP#1 -2 <br /> Page 2 of 3 <br /> Monitoring System Certification <br />