Laserfiche WebLink
Monitoring System Certification . • <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 329.01 <br /> -COm tete the following checklist: <br /> ® Yes ❑ No* Is the audible alarm operational? <br /> ® Yes ❑ No* Is the visual alarm operational? <br /> ® Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes El No* Were all sensors installed at lowest point of secondary containment and positioned so 7other1will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) <br /> ® N/A operational? <br /> ® Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak,fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ® Sump/Trench Sensors; ® Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ® Yes; ❑No. <br /> ® Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no <br /> ❑ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? 90% <br /> FMYes* <br /> ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replacedand list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ No Was liquid found inside any secondary containment systems designed as dry systems? (Check allthat apply) <br /> ❑Product; ® Water. If yes,describe causes in Section E,below. <br /> ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports, if applicable <br /> ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: Found very small amount of rain water in all STP sumps. Removed rain water from STP sumps and <br /> placed it into a 55 gal r1r,-to Wrendy located on site <br /> Page 2 of 4 <br />