Laserfiche WebLink
V iitoring System Certification <br /> Site Address • 1535 E PESCADERO AVE Date of Testing/Service: `0/24/2011 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 327.04 <br /> Complete the following checklist: <br /> X Yes No' Is the audible alarm operational? <br /> Q Yes No. Is the visual alarm operational? <br /> ❑ Yes FXJ No• Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not <br /> Yes E]No <br /> interfere with their proper operation? <br /> X Yes No• N/A If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem)operational? <br /> For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment <br /> ❑ Yes ❑No• QX WA monitoring system detects a leak,fails to operate,or is electrically disconnected?If yes:which sensors initiate positive <br /> shut-down?(check all that apply) ❑ Sumpfrrench Sensors; ❑ Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑ Yes El No <br /> ❑ Yes ❑No- NIA For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.:no mechanical <br /> overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fill points(s)and operating <br /> properly? If so,at what percent of tank capacity does the alarm trigger? <br /> ❑ ym• 01I Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the <br /> manufacturer name and model for all replacement parts in Section E,below. <br /> ❑X Yes• ❑No Was liquid found inside any secondary containment systems designed as dry systems?(check all that apply) ❑Product: <br /> ❑x Water. If yes,describe causes in Section E,below. <br /> ❑X yes ❑No• Was monitoring system set-up reviewed to ensure proper settings?Attach set-up reports,if applicable. <br /> ❑ Yes ❑X No Is all monitoring equipment operational per manufacturers'specifications? <br /> 'In Section E below,describe how and when these deficiences were or will be corrected. <br /> E. Comments: <br /> UNABLE TO TEST L 6 WASTE OIL ANNULAR DUE TO NO SENSOR IN TANK UNDER REPAIR AL PILL BUCKET <br /> Page 2 of 3 Based on CA form dated 03/08 <br />