Laserfiche WebLink
VW008 09:53 FAX 510 614 8396 PARADISO MECHANICAL 1121008 <br /> • • <br /> Mr. Don Mukai - 2 - <br /> CONV-62000 product literature; State Registered Professional Engineer Approval letter, <br /> Conversion Frame Specifications; and Bravo Conversion Frame Installation Instructions. <br /> State Water Board staff also visited the Bravo production facility where the CONV- <br /> B2000 is manufactured. A California registered Professional Engineer has reviewed the <br /> Bravo catalog sheet with specifications and the 82000 Conversion Frame Installation <br /> Instructions and has concluded that the frame is acceptable for adapting an existing <br /> installed UDC to a new dispenser (See Enclosure). <br /> Conditions of Approval <br /> Based on the Professional Engineer's review and the documentation you've submitted, <br /> we are granting approval of the CONV-62000 under the following conditions: <br /> 1. This model comes in several sizes in order to accommodate various dimensions <br /> of UDC and dispenser. Schematics of all existing and future sizes for the CONV- <br /> B2000 shall be made available upon request of the State Water Resources <br /> Control Board (State Water Board). <br /> 2. Materials and procedures employed in the construction of the CONV-132000 shall <br /> remain the same as the materials that were indicated in the documents reviewed <br /> by the State Water Board. <br /> 3. Installation procedures in no way supersede local, State, and federal regulations. <br /> Installers must obey all local laws, regulations, and requirements when installing <br /> the CONV-132000. <br /> 4. The procedures (Bravo Conversion Frame Installation Instructions, dated <br /> 3125/08) submitted in the approval process must be followed in their entirety. <br /> Any variations in the installation procedures must be reviewed and approved by <br /> the State Water Board. <br /> 5. Only installers meeting the requirements of CCR, Title 23, section 2715(h), <br /> including training and certification by the manufacturer(S. Bravo Systems, Inc.), <br /> are allowed to install this product. <br /> 6. Final authority to approve the use of the CONV-62000 in a particular jurisdiction <br /> rests with the local regulatory agency. The local agency may require pre- <br /> approval, permit, and/or inspection of the installation by either local agency staff <br /> or a registered professional engineer(special inspector)who has education and <br /> experience with underground storage tank system installations. <br /> 7. Per CCR, § 2636(f)(1) the UDC must be equipped with a continuous monitoring <br /> system that either activates an audible and visual alarm or stops the flow of <br /> California Environmental Projection Agency <br /> 0 RerycledPuper <br />