Laserfiche WebLink
Be sure to always READ THE DRAWINGS or plans to make <br /> I sure that your mounting points are the same. Call Bravo <br /> Systems if any problem occurs. <br /> A2 - Position and bolt down conversion frame to the dispenser pan using the anchor plates of the <br /> conversion frame with minimum 1/2" Diameter bolts. Use plastic caps to cover the bolts/nuts. <br /> For Non-Bravo Sumps - A minimum of Four anchor bolts must be secured directly to concrete. <br /> A3 - Adjust electrical conduits to line up with the new dispenser if necessary. <br /> A4 - Pre-plumb all product inlets and vapor recovery line with offsets and/or rigid pipe and elbows <br /> if necessary. <br /> if DEPENDING ON NEW DISPENSER USED AND/OR <br /> ff 1 1-01 trig 11 OFFSET APPLICATION, THE RISER ON THE DISPENSER MAY <br /> NEED TO BE SHORTENED TO ACCOMMODATE THE SPACE <br /> TAKEN UP BY THE USE OF OFFSETS, ELBOWS, ETC... <br /> A5 - Position and bolt down the dispenser to the conversion frame with the anchor bolts provided. <br /> Filter <br /> Filter <br /> Filter <br /> Dispenser <br /> Base I/dAorC/n Meters <br /> e <br /> BRAVO <br /> OFFSET <br /> Anchor BoltBRAV O <br /> OFFSET <br /> -- Cocnrete Anchor <br /> Anchor Bolts <br /> Plate r-M Fmo <br /> ° <br /> e BRAVO BOX <br /> ° $ FOR OLD Equipment shown is for <br /> DISPENSER illustration purposes only <br /> 4' a. <br /> b , <br /> a s <br /> and is not a reference <br /> 'or <br /> your layout within <br /> the hydraulic cabinet <br /> 2 ii-Conversion Frame 3-25-08 <br />