Laserfiche WebLink
D. Results of TestinglServicing • <br /> AUG 0 3 2017 <br /> Software Version Installed'. <br /> Com tete the followin checklist: _ <br /> ® Yes ❑ No' Is the audible alarm operational? `— <br /> ® Yes Q No' Is the visual alarm operational? _ T <br /> MENI <br /> ® Yes ❑ No' Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No' If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> ® N/A <br /> ® Yes ❑ No` For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br /> ❑ N/A fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut-down? (Check all that apply) 0 Sumpfrrench <br /> Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ®Yes; ❑No. <br /> ❑ Yes ❑ No' For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e., no mechanical overfill prevention valve is <br /> ® N/A installed),is the overfill warning alar visible and audible at the tank fill point(s)and operating property? If so,at what percent of tank capacity <br /> does the alar trigger? <br /> ❑ Yes ® No Was <br /> maderlformonitoring <br /> ecernentnt replaced? <br /> n Section es below.ry specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and <br /> parts <br /> ❑Yes' ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> ® Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> 0 Yes ❑ No' i Is all monitoring equipment operational per manufacturer's specifications? <br /> `In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. comments: 87 FLOAT ON DISP 1-2 NEEDS TO BE REPLACED ELITE IV TO REPAIR & RETEST <br /> Monitoring System Certification <br /> Page 2 of 4 2/21/07 <br />