Laserfiche WebLink
aBEAUDREAU MODEL 508 <br /> IMPACT SENSOR SYSTEM <br /> BEAUDREAU ELECTRONICS INC. <br /> The Model 508 Impact Sensor <br /> System is designed to provide <br /> gasoline stations with addi- <br /> tional protection against the <br /> threat of catastrophic fires andE, <br /> E NOJnlo633 Mmoa <br /> explosions caused by vehicles " n" .I E, <br /> Q lt��c,V <br /> hitting gasoline dispensers. <br /> The Model 508 Impact Sensor O El O O O <br /> is mounted inside the gasoline <br /> dispenser and continuously • "°"' • <br /> • Amo,,.., ,_.... � <br /> monitors for vehicular impact. <br /> When an impact is detected, oiX, <br /> and <br /> power to the dispenser <br /> submersible pumps can be <br /> shut off immediately. By shut- <br /> ting off both the electrical power and the pressurized fuel lines, the risk of a deadly fire and <br /> explosion occurring can be greatly reduced. The Model 508 Impact Sensor System can also be <br /> programmed to communicate to a third-party alarm system for faster emergency response. For <br /> more information, contact Beaudreau at 1-800-739-4435. <br /> SYSTEM OPERATION <br /> rThe Model 508 Impact Sensor System is designed to connect directly to the dispenser electrical junction box, <br /> eliminating the need for installing new conduit and pulling new wires. This allows sites to be easily upgraded <br /> with dispenser impact protection. Upon detecting vehicular impact,the Model 508 Impact Sensor System trans- <br /> mits an alarm across existing electrical wiring to the 522 Monitoring System located inside the station. The 522 <br /> Monitoring System will shut off electrical power to the dispenser and submersible pumps. As an additional <br /> safety feature, the 522 Monitoring System can also be programmed to communicate alarms to a third-party <br /> alarm system. The Model 508 Impact Sensor System uses the Model 500 Controller, the same basic controller <br /> as Beaudreau's leak detection system. If dispenser sump monitoring is also required, any of Beaudreau's sump <br /> sensors can be used in conjunction with the impact sensor system. <br /> SPECIFICATIONS <br /> "MTp,' Sensor: 508 Controller: 500 Monitoring System: 522RMS and 522SRS <br /> Dimensions Sensor: 3" x 1" dia. Controller: 3" x 4.25" dia. Mon.System: 5.5" x 4.25" x 2" <br /> W60S Vehicular Impact <br /> Listings Listed for use in Class 1,Division 1, Group D Hazardous Locations (ETL) <br />