Laserfiche WebLink
FOR AUTHORIZED USE ONLY DO NOT TAMPER ITH THE SYSTEM <br /> System Setup <br /> Each 500C Controller that has been installed at a dispenser has an individual serial number. <br /> This serial number should be written on the controller label or housing. Always make a <br /> list matching the controller serial numbers with the dispensers in which the controllers <br /> have been installed. The serial numbers will begin to be transmitted by the 500C Controller <br /> when power to the dispensers are turned on. In order for alarm data to be received, it is <br /> necessary to assign the serial number for each dispenser. <br /> 1. Plug the 522 Remote Monitoring System transformer into the dedicated outlet described in the <br /> previous section and as shown on pages 3-7. Turn on power to dispenser 1 only. <br /> 1. Press Escape to get to Main Menu <br /> Main Menu <br /> Monitoring Mode <br /> 2. Press —+key until the following screen appears: <br /> Main Menu <br /> System Setup <br /> 3. Press Enter <br /> Select Action <br /> Assign Disp <br /> 4. Press Enter <br /> Select Disp # <br /> Disp #01 <br /> 5. Press Enter <br /> Select Serial # <br /> 00000000 <br /> Dispenser#1's serial number will be displayed-if screen says N/A, wait approximately 30 <br /> seconds. <br /> 7. Press Enter <br /> Disp Assigned! <br /> n P-2 <br /> u <br />