Laserfiche WebLink
Don K . Mukai <br /> MECHANICAL ENGINEER <br /> 1841 Paloma St. Pasadena, CA 91104 <br /> March, 19, 2014 323-888-4136 <br /> Ms.Paola Bravo <br /> S. Bravo Systems,Inc. <br /> 2929 Vail Ave. <br /> Commerce, CA 90040 <br /> Re: Specification approved by a state registered professional engineer <br /> CCR Title 23,Division 3, Chapter 16,Article 3, Section 2631(d) <br /> This letter is for an engnieering specification review and approval of a secondary containment <br /> system component which is not an integral part of primary containment for an underground <br /> fuel tank storage system in California. The authority for this approval comes from the <br /> California Code of Regulations (CCR) Title 23, Division 3, Chapter 16, Article 3, Section <br /> 2631(d). <br /> I have examined and reviewed the following specifications on the Bravo FLX-Series fiberglass <br /> split retrofit fittings for flexible piping systems: <br /> 1) UL Certifications Directory MH26018 for Vipel F-764 and F-774 resins <br /> 2) AOC Vipel Product Selection Guide&Corrosion Resistance Guide <br /> 3) Bravo datasheets FLX-Retrofit-S-13A,FPE-Series-SW-14A,F-Series-Retrofit-S-I4A, <br /> FPE-RETROFIT-SI-12A and FLX_FlexPipe_D_Chart-14A <br /> 4) Bravo 2D CAD drawing package CAD-FLX-SERIES <br /> 5) Bravo Installation Manuals ii-FLX-RETROFIT-13A, ii-FPE-SERIES-SW-12A, <br /> ii-FPE-RETROFIT-13A and ii-F-SERIES-RETROFIT-S-13B <br /> 6) Bravo Third Party documents 3RP-F-Series, 3RP-FPE-Series,3RP-FPE-Retrofit-Si and <br /> 3RP-FS-Retrofit-S <br /> 7) UL certificate of compliance document UL-ULC_BRAVO_FSERIES dated 2-28-14 <br /> 8) Bravo fuel/alternative fuel compatibility letters for sumps and fittings(R3 versions) <br /> 9) Bravo ADHESIVE-EPDXY-KIT and ADHESIVE-EPDXY-RETROFIT-KIT <br /> 10) Bravo ADHESIVE-PE-KIT and ADHESIVE-NYLON-KIT <br /> This system provides a bonded retrofit solution to replace a suspect or failing entry fitting from the <br /> inside of a single wall fiberglass containment sump.This product maintains the integrity of a single <br /> walled containment sump by being permanently bonded to the fiberglass sump wall and pipe with <br /> fiberglass epoxy.The area of the flexible pipe that the fitting is installed to is converted to fiberglass <br /> by way of a split fiberglass sleeve that is bonded directly to the pipe via appropriate adhesive type <br /> which depends on the exterior surface material. Once the sleeve is installed, the primary fiberglass <br /> split fitting can be installed,completing the seal made between the pipe and containment sump wall. <br /> Continued on Page 2... <br /> 3RP-FLX-Series PAGE 1 oft <br />