Laserfiche WebLink
4 GILUKO <br /> t4.,_4 VEEDER-ROOT <br /> FMS COSTCO BIR INSTRUCTIONS : <br /> Costco is installing BIR at about 350 locations. Many of which will require a cold start. We will need to dial in, <br /> verify communications and also the setup programming before the ASC leaves the site. <br /> 1. No change in communications number is required. Dial the location and verify that you are able to get data back <br /> 2. Run a startup script MAKE SURE YOU ARE TYPING IN THE CORRECT GVR ID <br /> 3. Let the startup script finish COMPLETELY. It is important that it updates the setup information at the end. <br /> 4. Perform a 3 minute call back <br /> 5. Verify you get the call back <br /> 6. Now go to the setup monitoring screen. <br /> a. Change the Current Display to ALL <br /> b. Change the Display matches to non-Matches <br /> c. Push Load <br /> 7. Review the non-matching items with the ASC to determine why they are different than the approved value. <br /> Obviously the new BIR data commands may not match since BIR was not installed previously these values can be <br /> accepted but the other non-matching values should be confirmed with the ASC. <br /> 8. If changes are required either you or the ASC will need to make them. If the ASC makes them you will have to <br /> update the setup screen. <br /> a. Procomm —bring up the setup command GUI and type in the corresponding command with an i. Example <br /> i60200 (update tank labels) <br /> b. Devcom —Click the"Store response in DB"checkbox on the bottom right, type the I command in the <br /> command list and push enter <br /> 9. You are complete when your setup monitoring screen shows that there are no longer any items that do not match <br /> and you received a 3 minute call back from the locations. <br />